Abstract:Achieving a viable process for three-dimensional (3D) printing of ceramics is a sought-after goal in a wide range of fields including electronics and sensors for harsh environments, microelectromechanical devices, energy storage materials, and structural materials, among others. Low laser absorption of ceramic powders renders available additive manufacturing (AM) technologies for metals not suitable for ceramics. Polymer solutions that can be converted to ceramics (preceramic polymers) offer a unique opportunity to 3D-print ceramics; however, due to the low viscosity of these polymers, so far, their 3D printing has only been possible by combining them with specialized light-sensitive agents and subsequently cross-linking them layer by layer by rastering an optical beam. The slow rate, lack of scalability to large specimens, and specialized chemistry requirements of this optical process are fundamental limitations. Here, we demonstrate 3D printing of ceramics enabled by dispensing the preceramic polymer at the tip of a moving nozzle into a gel that can reversibly switch between fluid and solid states, and subsequently thermally cross-linking the entire printed part "at-once" while still inside the same gel. The solid gel, which is composed of mineral oil and silica nanoparticles, converts to fluid at the tip of the moving nozzle, allows the polymer solution to be dispensed, and quickly returns to a solid state to maintain the geometry of the printed polymer both during printing and the subsequent high-temperature (160 °C) cross-linking. We retrieve the cross-linked part from the gel and convert it to ceramic by high-temperature pyrolysis. This scalable process opens up new opportunities for low-cost and high-speed production of complex three-dimensional ceramic parts and will be widely used for high temperature and corrosive environment applications, including electronics and sensors, microelectromechanical systems, energy and structural applications.

Open Ceramics

Mid-infrared optical coherence tomography and machine learning for inspection of 3D-printed ceramics at the micron scale

Signal-Decay Based Approach for Visualization of Buried Defects in 3-D Printed Ceramic Components Imaged with Help of Optical Coherence Tomography

Rapid non-destructive inspection of sub-surface defects in 3D printed alumina through 30 layers with 7 μm depth resolution

Tomographic Volumetric Additive Manufacturing of Silicon Oxycarbide Ceramics

Additive manufacturing in ceramics: targeting lightweight mirror applications in the visible, ultraviolet and X-ray

Advances and Challenges in Direct Additive Manufacturing of Dense Ceramic Oxides

Industrial potential of additive manufacturing of transparent ceramics: A review

Three-Dimensional Printing of Ceramics through "Carving" a Gel and "Filling in" the Precursor Polymer

High-resolution multiceramic additive manufacturing based on digital light processing

Innovative and novel manufacturing methods of ceramics and metal-ceramic composites for biomedical applications

Additive manufacturing of polymer‐derived ceramic matrix composites

A critical review of direct laser additive manufacturing ceramics

Lithography-based additive manufacturing of ceramics: Materials, applications and perspectives

UV-Curing Assisted Direct Ink Writing of Dense, Crack-Free, and High-Performance Zirconia-Based Composites With Aligned Alumina Platelets

An Overview of Laser Engineered Net Shaping of Ceramics

Embedded 3D Printing of Architected Ceramics via Microwave‐activated Polymerization

Digital light processing 3D printing of ceramic materials: a review on basic concept, challenges, and applications

UV-assisted Robotic Arm Freeforming of SiOC Ceramics from a Preceramic Polymer

Preparation and stereolithography 3D printing of ultralight and ultrastrong ZrOC porous ceramics

3D printing of ceramics: Advantages, challenges, applications, and perspectives