Abstract:Lithium-ion (Li-ion) cells are the optimal choice of energy storage for battery electric vehicles. As the Li-ion cells must operate in a temperature range of 15–45 °C for optimal performance and life, thermal control of the cells is paramount. The study uses infrared imaging to investigate the temperature dynamics of two lithium-ion pouch cells with two energy capacities, 60 Ah and 20 Ah under different operational scenarios with natural convection. Experimental analysis conducted at ambient temperatures of 27 °C, 35 °C, and 40 °C reveals the necessity of cooling for the 20 Ah cell at temperatures exceeding 40 °C and C-rates beyond 1C. Similarly, thermal management is recommended for the 60 Ah cell at ambient temperatures of 35 °C and above, as temperatures surpass the 45 °C desirable threshold during charging and discharging rates of 1C and higher. Further studies are concentrated on the 60 Ah cell due to its increased cooling demands in comparison to the 20 Ah cell. The 60 Ah cell is modelled using NTGK and ECM electrochemical models and validated against experimental data, showing a good agreement within ±10% between both models and the experimental study. Finally, numerical simulations explain the efficacy of localized cooling with forced convection of liquid and performance metrics are introduced to evaluate the cooling efficiency of design configurations. Based on performance metrics, the T-shaped cold plate design, with an inlet coolant temperature of 30 °C, achieved the highest performance index of 1.13. This design notably decreased the maximum temperature and maximum temperature difference by 41.8% and 31.8%, respectively, compared to natural convection. This improvement is observed during the discharge of 60 Ah cell at 2C in a 40 °C environment, where the cell demands substantial cooling measures. Therefore, implementing localized cooling for the cell demonstrates its effectiveness in regulating temperature increase, leading to a significant decrease in the infrastructure requirements and weight of the thermal management system.

Thermal characteristics of pouch lithium–ion battery capacitors based on activated carbon and LiNi1/3Co1/3Mn1/3O2

Experimental and Numerical Study of PCM Thermophysical Parameters on Lithium-Ion Battery Thermal Management

Thermal behavior analysis of lithium-ion capacitors at transient high discharge rates

Thermal Safety Characteristic Analysis of Large‐Format Pouch Li‐Ion Capacitors

Thermal characteristics of ultrahigh power density lithium-ion battery

Numerical and experimental study on thermal behavior of prismatic lithium-ion battery for large-capacity energy storage

Determination on the Inherent Thermal Conductivity and Thermal Contact Resistance of Individual Thin-Layer Materials in Li-ion Batteries

Silicon dioxide-enhanced composite phase change materials for the thermal management of retired lithium-ion batteries

Preparation of thermally conductive composite phase change materials and its application in lithium-ion batteries thermal management

Depth-dependent understanding of the degradation mechanisms for typical LiNi0.5Co0.2Mn0.3O2/artificial graphite lithium-ion batteries upon high-temperature storage

Evaluating the heat generation characteristics of cylindrical lithium-ion battery considering the discharge rates and N/P ratio

Performance Degradation of Lithium‐Ion Batteries with LiNi 0.33 Co 0.33 Mn 0.33 O 2 Cathodes during Long‐Term, High‐Temperature Storage: Behaviors and Mechanism

A novel flexible composite phase change material applied to the thermal safety of lithium-ion batteries

Experimental Analysis on the Thermal Management of Lithium-Ion Batteries Based on Phase Change Materials

High-temperature Aging Behavior of Commercial Li-Ion Batteries

In‐situ and Real‐time Monitoring the Chemical and Thermal Evolution of Lithium‐ion Batteries with Single‐crystalline Ni‐rich Layered Oxide Cathode

Segmented bi-material cathodes to boost the lithium-ion battery-capacitors

Thermal Modeling of a Lithium-Ion Battery Module for Energy-Storage Applications

Thermoregulating Separators Based on Phase‐Change Materials for Safe Lithium‐Ion Batteries

Thermal characterization of pouch cell using infrared thermography and electrochemical modelling for the Design of Effective Battery Thermal Management System

Thermal simulation and prediction of high-energy LiNi0.8Co0.15Al0.05O2//Si-C pouch battery during rapid discharging