Abstract:Sorption-enhanced steam reforming of ethanol (SE-SRE) with in-situ CO2 removal is an environmentally friendly and sustainable approach for hydrogen production. Researches on continuous production of high-purity H2 by SE-SRE over the modified Li4SiO4 sorbent were conducted using two parallel reactor in this work. The low cost Li4SiO4 derived from rice husk ash (RHA) is a promising high-temperature CO2 sorbent. However, the poor adsorption kinetics of RHA-Li4SiO4 sorbent at low CO2 concentration is the major challenge. The metallic elements (K, Ca, Al, Mg) were employed to modify the RHA-Li4SiO4 for efficient CO2 capture. The developed sorbents were characterized and tested to study the role of dopants on the crystal, textural, microstructure and CO2 adsorption kinetics and cyclic stability. Results indicated that K doping effectively inhibited the growth of crystal aggregation and resulted in a fluffy morphology with abundant pores and higher specific surface area, while the addition of Ca, Al and Mg formed a nubby structure with larger particle size. K-doped RHA-Li4SiO4 exhibited the best CO2 uptake properties and the optimal K doping molar content was 0.02 with the maximum capture capacity of 34.16 wt%, which is higher than 27.1 wt% of pure RHA-Li4SiO4. Then, the effect of operating conditions on the enhancement behaviors was considered in the SE-SRE system. High-purity H2 (above 96%) was achieved by coupling K(0.02)/RHA-Li4SiO4 sorbent with Ni-based catalyst under the optimum condition (T: 525 °C, liquid hourly space velocity: 0.9 mL/(g·h), sorbent/catalyst: 4 and steam/carbon: 8.0). The adsorption activity of K(0.02)/RHA-Li4SiO4 maintained at a high level in ten SE-SRE/regeneration cycles. Finally, a scheme including two parallel fixed-bed reactors was designed and operated periodically for continuous production of high-purity H2. The reaction switching time was shown to depend strongly on the pre-breakthrough time and operating conditions. As the reaction switching time was 40 min, the products were always only H2 and CH4 (no CO and CO2 appear) and the H2 purity remained above 90% during 400 min, confirming high purity hydrogen stream can be obtained continuously.

Chemical looping steam reforming of ethanol without and with in-situ CO2 capture

The ReSER-COG Process for Hydrogen Production on a Ni–CaO/Al2O3 Complex Catalyst

The Coupling Performance During Reactive Sorption Enhanced Reforming (reser) Process: Simulation and Experimental Studies

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

Synergistic promotions between high purity H 2 production and CO 2 capture via sorption enhanced chemical looping reforming

Renewable hydrogen production from chemical looping steam reforming of biodiesel byproduct glycerol by mesoporous oxygen carriers

Sorption-enhanced chemical looping steam reforming of glycerol with CO 2 in-situ capture and utilization

Co-production of syngas and H2 from chemical looping steam reforming of methane over anti-coking CeO2/La0.9Sr0.1Fe1−xNixO3 composite oxides

Pt–calcium cobaltate enables sorption‐enhanced steam reforming of glycerol coupled with chemical‐looping CH 4 combustion

Sorption-enhanced Chemical Looping Steam Reforming Coupled with Water Splitting for Syngas and H2 Coproduction Using Waste Plastic As Fuel

Continuous high-purity hydrogen production by sorption enhanced steam reforming of ethanol over modified lithium silicate

Uniformly dispersed NiFeAlO 4 as oxygen carrier for chemical looping steam methane reforming to produce syngas

Performance evaluation of rare earth (La, Ce and Y) modified CoFe2O4 oxygen carriers in chemical looping hydrogen generation from hydrogen-rich syngas

Enhanced hydrogen production via catalytic toluene reforming with in situ carbon dioxide capture: Effects of a hybrid iron-calcium composite prepared by impregnation

A Novel Chemical Looping Combustion (CLC)-Assisted Catalytic Naphtha Reforming Process for Simultaneous Carbon Dioxide Capture and Hydrogen Production Enhancement

Investigations on oxygen carriers derived from natural ores or industrial solid wastes for chemical looping hydrogen generation using biomass pyrolysis gas

Syngas production via chemical looping reforming using methane-based feed and NiO/Al2O3 oxygen carrier

Chemical Looping Combustion-Adsorption Of Hcl-Containing Syngas Using Alkaline-Earth Coated Iron Ore Composites For Simultaneous Purification And Combustion Enhancement

Performance of Ceo2-Modified Iron-Based Oxygen Carrier in the Chemical Looping Hydrogen Generation Process

Improving the carbon resistance of iron-based oxygen carrier for hydrogen production via chemical looping steam methane reforming: A review

Crystalline phase transformation of Sr-Fe based oxygen carriers modulate the cyclic performance for syngas and CO coproduction in chemical looping ethanol reforming coupled with CO 2 splitting