Abstract:Sorption-enhanced steam reforming of ethanol (SE-SRE) with in-situ CO2 removal is an environmentally friendly and sustainable approach for hydrogen production. Researches on continuous production of high-purity H2 by SE-SRE over the modified Li4SiO4 sorbent were conducted using two parallel reactor in this work. The low cost Li4SiO4 derived from rice husk ash (RHA) is a promising high-temperature CO2 sorbent. However, the poor adsorption kinetics of RHA-Li4SiO4 sorbent at low CO2 concentration is the major challenge. The metallic elements (K, Ca, Al, Mg) were employed to modify the RHA-Li4SiO4 for efficient CO2 capture. The developed sorbents were characterized and tested to study the role of dopants on the crystal, textural, microstructure and CO2 adsorption kinetics and cyclic stability. Results indicated that K doping effectively inhibited the growth of crystal aggregation and resulted in a fluffy morphology with abundant pores and higher specific surface area, while the addition of Ca, Al and Mg formed a nubby structure with larger particle size. K-doped RHA-Li4SiO4 exhibited the best CO2 uptake properties and the optimal K doping molar content was 0.02 with the maximum capture capacity of 34.16 wt%, which is higher than 27.1 wt% of pure RHA-Li4SiO4. Then, the effect of operating conditions on the enhancement behaviors was considered in the SE-SRE system. High-purity H2 (above 96%) was achieved by coupling K(0.02)/RHA-Li4SiO4 sorbent with Ni-based catalyst under the optimum condition (T: 525 °C, liquid hourly space velocity: 0.9 mL/(g·h), sorbent/catalyst: 4 and steam/carbon: 8.0). The adsorption activity of K(0.02)/RHA-Li4SiO4 maintained at a high level in ten SE-SRE/regeneration cycles. Finally, a scheme including two parallel fixed-bed reactors was designed and operated periodically for continuous production of high-purity H2. The reaction switching time was shown to depend strongly on the pre-breakthrough time and operating conditions. As the reaction switching time was 40 min, the products were always only H2 and CH4 (no CO and CO2 appear) and the H2 purity remained above 90% during 400 min, confirming high purity hydrogen stream can be obtained continuously.

Synergistic promotions between high purity H 2 production and CO 2 capture via sorption enhanced chemical looping reforming

The Characteristics of A Sorption-Enhanced Steam-Methane Reaction for the Production of Hydrogen Using Co2 Sorbent

The Coupling Performance During Reactive Sorption Enhanced Reforming (reser) Process: Simulation and Experimental Studies

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

Sorption-enhanced Chemical Looping Steam Reforming Coupled with Water Splitting for Syngas and H2 Coproduction Using Waste Plastic As Fuel

Pt-Calcium-Cobaltate Enables Sorption-Enhanced Steam Reforming of Glycerol Coupled with Chemical Looping CH4 Combustion

Chemical looping steam reforming of ethanol without and with in-situ CO2 capture

Sorption-enhanced Chemical Looping Steam Reforming of Glycerol with CO2 In-Situ Capture and Utilization

Sorption-enhanced chemical looping steam reforming of glycerol with CO 2 in-situ capture and utilization

High-Purity Hydrogen Production by CO 2 Addition for Sorption-Enhanced Steam Methane Reforming at a Temperature Below 600 °C

Continuous high-purity hydrogen production by sorption enhanced steam reforming of ethanol over modified lithium silicate

Pt–calcium cobaltate enables sorption‐enhanced steam reforming of glycerol coupled with chemical‐looping CH 4 combustion

Steam Methane Reforming Reaction Enhanced by a Novel K2CO3-Doped Li4SiO4 Sorbent: Investigations on the Sorbent and Catalyst Coupling Behaviors and Sorbent Regeneration Strategy

High purity hydrogen production via coupling CO2 reforming of biomass-derived gas and chemical looping water splitting

High purity hydrogen production via coupling CO 2 reforming of biomass-derived gas and chemical looping water splitting

Hydrogen production and CO 2 capture from Linz-Donawitz converter gas via a chemical looping concept

Production of High-Purity H2 Through Sorption-Enhanced Water Gas Shift over a Combination of Two Intermediate-Temperature CO2 Sorbents

Mid-temperature Chemical Looping Methane Reforming for Hydrogen Production Via Iron-Based Oxygen Carrier Particles

Chemical looping co-conversion of CH4 and CO2 using Fe2O3/Al2O3 pellets as both oxygen carrier and catalyst in a fluidized bed reactor

Calcium Cobaltate: a Phase-change Catalyst for Stable Hydrogen Production from Bio-glycerol

High-throughput Design of Complex Oxides As Isothermal, Redox-Activated CO2 Sorbents for Green Hydrogen Generation