Abstract:The use of welded I-section steel members with longitudinally profiled (LP) steel plates is becoming popular in structures, and such members are manufactured with variable thickness to accommodate the loading distributions in practical construction. Compared with the constant thickness steel plates, the use of LP steel plates is more susceptible to local buckling at the thinner end. However, there was no study that reported the local buckling behaviour of such members. Furthermore, existing design codes do not provide any design guidance for calculating the strength of such steel members. In this paper, a total of sixteen welded I-shaped section stub columns with LP and constant thickness steel plates under axial compression were tested to study the local buckling behaviour of such members. The initial geometric imperfections of all specimens were measured using 3D laser scanning technology prior to the axial compression experiments. A nonlinear finite element (FE) model was also established, and validated against the corresponding experimental results, which showed a good agreement both in terms of ultimate strength and failure modes. An extensive parametric study including 130 FE models was conducted using validated FE models. To evaluate the feasibility and reliability of the existing design provisions for steel members with constant thickness steel plates, the test and numerical results were compared against design strength predicted from the existing design provisions. Upon comparison, the existing design formulas in Chinese Standard (GB 50017-2017), American Specification (ANSI/AISC 360-10) and European Standard (BS EN 1993-1-5) are found to be generally conservative when calculating the strength of such members with LP steel plates. New design formulas are proposed, in which the modified normalized slenderness ratio and enhancement coefficient are applied to the existing design provisions.

Stability bearing capacity of equal-leg angle steel columns with end connection joints

Testing, Modelling and Design of Aluminium Alloy Single-Angle Members Connected by One Leg under Eccentric Compression

Ultimate strength of pinned-end dual-angle cross combined section columns under axial compression

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Global Buckling Behavior of CFST Columns with Assembling Errors

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Global Buckling of S35657 Austenitic Stainless Steel Welded Box- and I-section Long Columns under Axial Compression

Experimental and numerical investigation on Local-Overall interactive buckling behavior of welded I-Section steel columns

Experimental study of end-plate joints with box columns

Experimental Study on Overall Buckling Behavior of Q420 High Strength Equal Angle Members under Axial Compression

Residual stress and compression buckling of large welded equal-leg steel angles

Column Buckling Tests of 420 Mpa High Strength Steel Single Equal Angles

Experimental Investigation and Numerical Analysis of Pin-Ended Extruded Aluminium Alloy Unequal Angle Columns

Tests and Finite Element Analysis on the Local Buckling of 420 MPa Steel Equal Angle Columns under Axial Compression

Local Buckling of Steel Equal Angle Members with Normal and High Strengths

INVESTIGATION ON DESIGN METHOD OF OVERALL BUCKLING BEHAVIOUR FOR Q420 HIGH STRENGTH STEEL EQUAL-LEG ANGLE MEMBERS UNDER AXIAL COMPRESSION

Numerical Study and Design Method for Lateral Torsional Buckling of High-Strength Steel Beams

Static Bearing Capacity Investigation of a Novel Prefabricated Light-Steel Beam–Column Connection

Static and Seismic Experimental Study of Novel Prefabricated Beam-Column Joints with Elongated-Hole Brackets

Study of Flexural–torsional Buckling Behaviour of 6061-T6 Aluminium Alloy Unequal-Leg Angle Columns

Local buckling behaviour of welded I-section steel stub columns with longitudinally profiled steel plates under axial compression: Testing, modelling and design