Abstract:In conjunction with the experimental investigation described in the paper [1], a numerical modeling programme has been carried out to investigate further the structural behaviour of high strength Q690 steel columns of welded H-sections under combined compression and bending. Finite element (FE) models were developed by using the FE package ABAQUS. Geometrical and material non-linearities were incorporated in the FE models. Through the validation against the experimental results, these FE models showed excellent capability of replicating the key test results, including failure modes, failure loads and full load-axial deformation and load-lateral deflection histories. Upon validation of the FE models, parametric studies were conducted focusing on the effect of member residual stresses and material yield to tensile strength ratios. Then a large number of FE models were established to generate additional structural performance data over a wide range of cross-section dimensions, member slenderness and initial loading eccentricity ratios. The FE model results were then compared with the design buckling resistances of columns under combined compression and bending according to the current European Standard EN 1993-1-1, American Specification ANSI/AISC 360-16 and Chinese Standard GB 50017-2003. The comparisons revealed that by properly selecting design parameters, the design rules in EN 1993-1-1 and GB 50017-2003 could provide close and safe predictions to the buckling resistances of Q690 steel columns of welded H-sections while the design rules in ANSI/AISC 360-16 was readily applicable to the design of Q690 steel columns of welded H-sections.

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Numerical Simulation Analysis and the Program for Steel-Concret Composite Long Column in Eccentricaly-loaded

Experimental and Numerical Study of 7A04-T6 Extruded Aluminium Alloy Lipped Angle Columns in Axial Compression

Numerical Studies on Full-Scale Steel Columns under Complex Seismic Loading

Stub Column Tests of Thin-Walled Complex Section with Intermediate Stiffeners

LOCAL BUCKLING OF THIN-WALLED HIGH STRENGTH STEEL COLUMNS WITH WEB STIFFENERS

Design of Austenitic and Duplex Stainless Steel SHS and RHS Beam-Columns

Numerical Analysis on Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns under Axial Compression

Experimental Investigation of Thin-Walled Complex Section Concrete-Filled Steel Stub Columns

Numerical Simulation and Specification Provisions for Cruciform Cold-Formed Steel Built-Up Columns

Behaviour and Design Calculations on Very Slender Thin-Walled Cfst Columns

Experimental and numerical investigation on Local-Overall interactive buckling behavior of welded I-Section steel columns

Experimental and numerical investigations of high strength steel welded h-section columns

Numerical investigation and design for the local buckling behaviour of high strength steel hexagonal hollow section stub columns under axial compression

Numerical Investigation into High Strength Q690 Steel Columns of Welded H-sections under Combined Compression and Bending

Numerical Simulation of Cold-Formed Steel Stiffened Lipped Channel Columns with and without Perforations

Experimental Study and Finite Element Analysis on Ultimate Strength of Dual-Angle Cross Combined Section under Compression

Experimental and Numerical Study on the Load-Bearing Capacity of Cold-Formed Stiffened High-Strength Steel Box Columns

Experimental and Numerical Study on the Behavior of Axially Compressed High Strength Steel Columns with H-Section

FINITE ELEMENT ANALYSIS AND DESIGN METHOD STUDY ON THE LOCAL BUCKLING OF 460 MEGAPASCAL HIGH STRENGTH STEEL I-SECTION COLUMNS UNDER AXIAL COMPRESSION

Behavior of Q690 High-Strength Steel Columns: Part 2: Parametric Study and Design Recommendations