Abstract:In this study, the eccentric compression properties of L-shaped columns fabricated using concrete-filled steel tubes connected by double vertical steel plates (LCFST-D columns) were experimentally studied. The eccentricity was used as a parameter to analyse the deformation development, failure mode and ultimate carrying capacity of these columns. The test result indicated that the LCFST-D columns had a good ductility and bearing capacity. Compared with LCFST columns under identical eccentricity, the LCFST-D columns had a higher bearing capacity, over 20%, and significantly higher ductility. The double vertical steel plates filled with concrete efficiently improved the collaboration among the monocolumns, strengthened their integrity and fully utilized the material properties. The test study used a finite element model to analyse the entire deformation process of LCFST-D columns and the interaction among monocolumns to determine the effects of the eccentricity, vertical steel plate thickness, and steel pipe thickness on the performance of these columns under eccentric compression. The test result showed that overall bending and buckling were the failure modes of the LCFST-D columns, during which the three monocolumns bulged first. The eccentricity was a key factor that affected the eccentric load bearing capacity of these columns. Increasing the eccentricity notably decreased the bearing capacity of the columns. Increasing the steel pipe thickness delayed the local buckling of a monocolumn, which increased its bearing capacity. Based on this analysis, a formula to predict the eccentric compression capacity of LCFST-D columns was proposed. The error between calculation results and test data was less than 10%, and the accuracy was verified by the test results.

Experimental and Numerical Investigation of Axially Loaded L-shaped Box-T Section Columns

Experimental and Numerical Study of 7A04-T6 Extruded Aluminium Alloy Lipped Angle Columns in Axial Compression

Investigation on Buckling Behavior of T-shaped Box-T Section Columns under Axial Load

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Experimental investigation of concrete-filled steel tubular columns with reinforcing lattice angle

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Numerical Research on Axial Compression Behavior of L-shaped Steel Reinforced Concrete Short Columns

Simplified design method of cold-formed steel columns with built-up box sections

Experimental study on multi-cellular L-shaped CFST slender columns under biaxial eccentric compression

Sectional Strength Design of L-Shaped Irregularly Concrete-Filled Steel Tube Column under Axial Compression and Any Directional Moment

Compressive Behavior and Design Calculations of CFST Slender Columns with Latticed Annular Steel Part

Analysis and Design of Concrete-Filled Stiffened Thin-Walled Steel Tubular Columns under Axial Compression

Behavior and design of axially loaded square concrete-filled double steel tubular slender columns

Research on interactive buckling behavior of welded steel box-section columns

Axial compression behaviour of welded high-strength H-columns experimental tests and numerical simulations

Experimental and numerical investigation on Local-Overall interactive buckling behavior of welded I-Section steel columns

Experimental Study and Finite Element Calculation of the Behavior of Special T-Shaped Composite Columns with Concrete-Filled Square Steel Tubulars under Eccentric Loads

EXPERIMENTAL STUDY ON THE BEHAVIOUR OF L-SHAPED COLUMNS FABRICATED USING CONCRETE-FILLED STEEL TUBES UNDER ECCENTRIC LOADS

Behavior of concrete-filled T-shaped steel tubular beam-columns under biaxial compressive loads

Experimental and Numerical Study of L-shaped Irregularly Concrete-Filled Steel Tube Columns under Axial Compression and Eccentric Compression

Axial compression behavior of prefabricated L-section thin concrete encased steel short columns