Abstract:We propose and demonstrate a new approach to implement a wavelength-tunable ultrafast fiber laser source suitable for multiphoton microscopy. We employ fiber-optic nonlinearities to broaden a narrowband optical spectrum generated by an Yb-fiber laser system and then use optical bandpass filters to select the leftmost or rightmost spectral lobes from the broadened spectrum. Detailed numerical modeling shows that self-phase modulation dominates the spectral broadening, self-steepening tends to blue shift the broadened spectrum, and stimulated Raman scattering is minimal. We also find that optical wave breaking caused by fiber dispersion slows down the shift of the leftmost/rightmost spectral lobes and therefore limits the wavelength tuning range of the filtered spectra. We show both numerically and experimentally that shortening the fiber used for spectral broadening while increasing the input pulse energy can overcome this dispersion-induced limitation; as a result, the filtered spectral lobes have higher power, constituting a powerful and practical approach for energy scaling the resulting femtosecond sources. We use two commercially available photonic crystal fibers to verify the simulation results. More specific, use of 20-mm fiber NL-1050-ZERO-2 enables us to implement an Yb-fiber laser based ultrafast source, delivering femtosecond (70-120 fs) pulses tunable from 825 nm to 1210 nm with > 1 nJ pulse energy. (C) 2016 Optical Society of America

Watt-level all polarization-maintaining femtosecond fiber laser source at 1100 nm

Watt-level all polarization-maintaining femtosecond fiber laser source at 1100 nm for multicolor two-photon fluorescence excitation of fluorescent proteins

589 nm laser generation by frequency doubling of a single-frequency Raman fiber amplifier in PPSLT.

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

208 W single-frequency 1064 nm laser based on a single-crystal fiber master-oscillator power amplifier

All-polarization-maintaining, semiconductor saturable absorbing mirror mode-locked femtosecond Er-doped fiber laser with a gigahertz fundamental repetition rate

Compact, repetition rate locked all-PM fiber femtosecond laser system based on low noise figure-9 Er:fiber laser

High-peak-power, single-frequency, single-mode, linearly polarized, nanosecond all-fiber laser based on self-phase modulation compensation

Power scaling of high-power linearly polarized fiber lasers with <10 GHz linewidth

165?MHz highly stable femtosecond Er:ZBLAN fiber laser operating at 2.8?μm

Ultrafast Polarization‐Maintaining Fiber Lasers: Design, Fabrication, Performance, and Applications

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

Femtosecond pulses generated from a compact all-polarization-maintaining (PM) Ytterbium-doped fiber laser

All-Fiber High-Power 3 GHz Ultrafast Laser System At 2.0 μm

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

115-Mhz Linear NPE Fiber Laser Using All Polarization-Maintaining Fibers

Hundred Nano-Joules Polarization-Maintaining Yb-Doped Fiber Femtosecond Laser Amplification System

Watt-level all-fiber 1.7-μm picosecond synchronously pumped Raman laser

Watts-Level Super-Compact Narrow-Linewidth Tm-Doped Silica All-Fiber Laser Near 1707 Nm with Fiber Bragg Gratings

High Energy, Monolithic Fiber Femtosecond Lasers

Nanosecond pulse pumped, fiber-integrated narrow linewidth linearly polarized Raman amplifier at 1120 nm