Abstract:A high-power 20/400-μm few-mode polarization-maintaining (PM) fiber amplifier with a radially polarized output beam is firstly demonstrated and investigated. The reconstructed beam profiles and mode contents of the output laser were obtained using a numerical method. Experimentally, a home-made fiberized mode convertor was employed to convert the LP01 mode to be TM01 mode (radially polarized beam) with an average power of 2 W. In addition, the mode purity and polarization purity were 98.76%, and 98.5%, respectively. Based on a few-mode PM fiber amplifier, instead of the commonly used non-PM fiber amplifier, the radially polarized beam was scaled up to 192.1 W, while preserving the donut-shaped intensity distribution. The corresponding mode purity and polarization purity were measured to be approximately 97% and 98.2%, respectively, which indicates the polarization characteristic of the TM01 mode was preserved well. The beam quality factor (M2) was measured to be ∼2.2. Additionally, long-term stability in terms of both output power and polarization state were also verified experimentally. To the best our knowledge, this is the highest output power from a few-mode PM fiber amplifier laser system, while maintaining a high mode purity and a high polarization purity for radially polarized beam.

Power scaling of high-power linearly polarized fiber lasers with <10 GHz linewidth

Nonlinearity Optimization of Dissipative-Soliton Fiber Laser for Generation of Pulses with 350 Kw Peak Power

1030 nm high power polarization maintained fiber laser with narrow linewidth and near diffraction limited beam quality

Kw-Level 1030 Nm Polarization-Maintained Fiber Laser with Narrow Linewidth and Near-Diffraction-limited Beam Quality.

589 nm laser generation by frequency doubling of a single-frequency Raman fiber amplifier in PPSLT.

Confined-doped fiber enabled kilowatt-level all-fiber laser with 1.28 GHz linewidth

High fidelity amplification of radially-polarized laser in few-mode polarization-maintaining fiber amplifier

High-peak-power, single-frequency, single-mode, linearly polarized, nanosecond all-fiber laser based on self-phase modulation compensation

Incoherently pumped high-power linearly-polarized single-mode random fiber laser: experimental investigations and theoretical prospects

PCF Based High Power Narrow Line Width Pulsed Fiber Laser

Narrow-linewidth Single-Polarization Fiber Laser Using Non-Polarization Optics.

All-fiberized and narrow-linewidth 5 kW power-level fiber amplifier based on a bidirectional pumping configuration

Narrow-linewidth high-efficiency single-frequency ytterbium-doped fiber laser with highly linear polarization at 1064 nm

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

3.38 kW all-fiberized narrow linewidth fiber laser based on active polarization control using RMS-Prop algorithm

High-power, 474 Fs, 31.12 MHz, All-Polarization-maintaining, 1560 Nm Fiber Laser System Based on the Chirped-Pulse Amplification

Watt-level all polarization-maintaining femtosecond fiber laser source at 1100 nm

All-fiber high-power linearly polarized supercontinuum generation from polarization-maintaining photonic crystal fibers

Tapered active fiber simultaneously enabled 141 W high average and 1.3 MW high peak power via all-fiber and polarization-maintained picosecond amplifier

3.3 Kw Narrow Linewidth FBG-based MOPA Configuration Fiber Laser with Near-Diffraction-limited Beam Quality

Investigations of the High-Power, Single-Frequency, Sub-Microseconds, 1548-nm Fiber Laser Based on the Optical Pulse Modulation