Abstract:The Yb:fiber based high-power and high-energy ultrafast lasers usually feature central wavelength of 1030 nm instead of the more common one of 1064 nm, thus limiting some potential wavelength-dependent applications. In this work, a hectowatt 1064-nm femtosecond chirped pulse amplification (CPA) system based on double-stage rod-type photonic crystal fiber (PCF) amplifier was demonstrated, with a pulse energy of 212-μJ and a repetition rate of 0.5 MHz. Compared with our previous work [Opt. Express 30(6), 3611, 2022], two key measures were employed. Firstly, a Yb:YAG crystal was intentionally introduced as a spectral filter for avoiding 1030-nm amplified spontaneous emission (ASE) oscillation, which hence improved the signal-to-noise ratio (SNR) by 15 dB. Secondly, an additional stage of rod-type PCF amplifier was adopted for further power scaling, achieving an average power of 127 W. Finally, the pulse was compressed to ∼460 fs, with an average power of 106 W and a compression efficiency of ∼83%. The beam quality factors (M2) were measured to be M2 X = 1.12 and M2 Y = 1.09. To the best of our knowledge, this is the highest pulse energy among 1064-nm hectowatt-level femtosecond lasers, thus providing a high-quality source for wavelength-dependent applications. For example, it can be used as a driver for high-repetition-rate vacuum ultraviolet (VUV) sources about 10.5 eV, with an expected conversion efficiency of up to 1%.

PCF Based High Power Narrow Line Width Pulsed Fiber Laser

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

Nonlinearity Optimization of Dissipative-Soliton Fiber Laser for Generation of Pulses with 350 Kw Peak Power

589 nm laser generation by frequency doubling of a single-frequency Raman fiber amplifier in PPSLT.

High-peak-power, single-frequency, single-mode, linearly polarized, nanosecond all-fiber laser based on self-phase modulation compensation

1030 nm high power polarization maintained fiber laser with narrow linewidth and near diffraction limited beam quality

High-Power GHz Burst-Mode All-Fiber Laser System with Sub 300 fs Pulse Duration

72-Kw High-Peak-power Linearly-Polarized Single-Mode Pulsed Fiber Laser with 80 Khz Repetition Rate and 4.5 Ns Duration

All-fiberized master oscillator power amplifier structured narrow-linewidth nanosecond pulsed laser with 505 W average power

Nanosecond pulse pumped, fiber-integrated narrow linewidth linearly polarized Raman amplifier at 1120 nm

All-fiberized and narrow-linewidth 5 kW power-level fiber amplifier based on a bidirectional pumping configuration

Kw-Level 1030 Nm Polarization-Maintained Fiber Laser with Narrow Linewidth and Near-Diffraction-limited Beam Quality.

High-power, 474 Fs, 31.12 MHz, All-Polarization-maintaining, 1560 Nm Fiber Laser System Based on the Chirped-Pulse Amplification

High Peak-Power and Narrow-Linewidth All-Fiber Raman Nanosecond Laser in 1.65 Μm Waveband.

Investigations of the High-Power, Single-Frequency, Sub-Microseconds, 1548-nm Fiber Laser Based on the Optical Pulse Modulation

3.3 Kw Narrow Linewidth FBG-based MOPA Configuration Fiber Laser with Near-Diffraction-limited Beam Quality

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

Power scaling of high-power linearly polarized fiber lasers with <10 GHz linewidth

396 MHz CPA femtosecond laser system based on a single crystal fiber rod-type amplifier

High-Power High Beam Quality Narrow-Linewidth Quasicontinuous Wave Microsecond Pulse 1064-Nm Nd:YAG Amplifier

Low repetition rate broadband high energy and peak power nanosecond pulsed Yb-doped fiber amplifier