Abstract:Previous studies on laterally loaded piles in clay have mainly focused on flexible and rigid piles. Little attention has been paid to semi-rigid piles (whose pile–soil stiffness lies somewhere between those of rigid and flexible piles), which may behave as either flexible piles or rigid piles, depending on the change in soil stiffness during cycling. This study aims to understand the cyclic lateral response of a repeatedly loaded semi-rigid pile in soft clay and the failure mechanisms of the soil around the pile, through a series of centrifuge model tests and three-dimensional finite element analyses using an advanced hypoplastic clay model. Numerical parametric studies were also performed to investigate the evolution of soil flow mechanisms with increasing pile rigidity. It is revealed that the semi-rigid pile behaved as if it were a flexible pile (i.e., flexural deformation dominated) during the first few cycles, but tended to behave like a rigid pile (i.e., rotational movement prevailed) during subsequent cycles, which progressively softened the surrounding soil. As a result, the mechanisms of soil flow around the semi-rigid pile exhibited an intermediate behaviour combining the mechanisms of both flexible and rigid piles. Three distinctive mechanisms were identified: a wedge-type mechanism near the surface, a full-flow mechanism (within the transverse sections) near the middle of the pile, and a rotational soil flow mechanism (in the vertical symmetrical plane of the pile) near the lower half of the pile. By ignoring the rotational soil flow mechanism, which has a much lower resistance than the full-flow mechanism, the American Petroleum Institute code (published in 2007) underestimated the cyclic bending moment and the lateral pile displacement by 10% and 69%, respectively. Application of jet grouting around the semi-rigid pile at shallow depth significantly altered the soil flow mechanism (i.e., it was a solely wedge-type mechanism around the grouted zone).

Calculation of Long Bored Piles for Vertical Loading

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

A NEW CALCULATION METHOD FOR LARGE-DIAMETER-TUBULAR-PILE BEARING CAPACITY

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

A Simplified Nonlinear Calculation Method to Describe the Settlement of Pre-Bored Grouting Planted Nodular Piles

Vertical Bearing Capacity of Large-Diameter Bored Pile

Field Tests on Behavior of Pre-Bored Grouted Planted Pile and Bored Pile Embedded in Deep Soft Clay

Calculation of Bored Piles in Rocky Soils Under the Action of Axial Compressive Load

A new nonlinear method for vertical settlement prediction of a single pile and pile groups in layered soils

A simplified approach to calculating settlement of a single pre-bored grouting planted nodular pile in layered soils

Field Behavior of Pre-Bored Grouted Planted Nodular Pile Embedded in Deep Clayey Soil

Vertically Loaded Cast-in-Place Piles in Clayey Soils and Their Analysis Based on Static-Penetration Data

CALCULATION OF THE EFFECTIVE LENGTH OF COMPRESSED BORED HANGING PILES BASED ON THE BEARING CAPACITY OF THE TWO-LAYER FOUNDATION SOIL.

Elastoplastic Solutions for Single Piles under Combined Vertical and Lateral Loads

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Vertical bearing capacity of rock-socketed pile with enlargement at pile end

Field study on the behavior of pre-bored grouted planted pile with enlarged grout base

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling