Abstract:Previous studies on laterally loaded piles in clay have mainly focused on flexible and rigid piles. Little attention has been paid to semi-rigid piles (whose pile–soil stiffness lies somewhere between those of rigid and flexible piles), which may behave as either flexible piles or rigid piles, depending on the change in soil stiffness during cycling. This study aims to understand the cyclic lateral response of a repeatedly loaded semi-rigid pile in soft clay and the failure mechanisms of the soil around the pile, through a series of centrifuge model tests and three-dimensional finite element analyses using an advanced hypoplastic clay model. Numerical parametric studies were also performed to investigate the evolution of soil flow mechanisms with increasing pile rigidity. It is revealed that the semi-rigid pile behaved as if it were a flexible pile (i.e., flexural deformation dominated) during the first few cycles, but tended to behave like a rigid pile (i.e., rotational movement prevailed) during subsequent cycles, which progressively softened the surrounding soil. As a result, the mechanisms of soil flow around the semi-rigid pile exhibited an intermediate behaviour combining the mechanisms of both flexible and rigid piles. Three distinctive mechanisms were identified: a wedge-type mechanism near the surface, a full-flow mechanism (within the transverse sections) near the middle of the pile, and a rotational soil flow mechanism (in the vertical symmetrical plane of the pile) near the lower half of the pile. By ignoring the rotational soil flow mechanism, which has a much lower resistance than the full-flow mechanism, the American Petroleum Institute code (published in 2007) underestimated the cyclic bending moment and the lateral pile displacement by 10% and 69%, respectively. Application of jet grouting around the semi-rigid pile at shallow depth significantly altered the soil flow mechanism (i.e., it was a solely wedge-type mechanism around the grouted zone).

Vertically Loaded Cast-in-Place Piles in Clayey Soils and Their Analysis Based on Static-Penetration Data

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

Calculation of Long Bored Piles for Vertical Loading

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Experimental Study on Vertical and Lateral Behaviour of Open Caisson Foundations in Clay

Analytical Elastoplastic Solutions of Laterally Loaded Long Piles

Field Behavior of Pre-Bored Grouted Planted Nodular Pile Embedded in Deep Clayey Soil

A Simplified Nonlinear Calculation Method to Describe the Settlement of Pre-Bored Grouting Planted Nodular Piles

A Field Study on the Behavior of Static Drill Rooted Nodular Piles with Caps under Compression

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling

A Model Test on the Behavior of A Static Drill Rooted Nodular Pile under Compression

Field Tests on Behavior of Pre-Bored Grouted Planted Pile and Bored Pile Embedded in Deep Soft Clay

Analysis of Axial Load-Transfer of Large-Diameter Cast-in-situ Tubular Pile

Model tests comparing the behavior of pre-bored grouted planted piles and a wished-in-place concrete pile in dense sand

Field study on the behavior of pre-bored grouted planted pile with enlarged grout base

A new nonlinear method for vertical settlement prediction of a single pile and pile groups in layered soils

Static Load Test of a Project CFG Pile Composite Foundation

A test on base bearing capacity of static drill rooted nodular pile

Vertical Load Effects on the Lateral Response of Piles in Layered Media

A simplified approach to calculating settlement of a single pre-bored grouting planted nodular pile in layered soils