Abstract:This study performed first-principle-based calculations of the interface adhesion work in interface models of three terminal systems: CrAlSiNSi/WC-Co, CrAlSiNN/WC-Co, and CrAlSiNAl/WC-Co. The results proved that the CrAlSiNSi/WC-Co and CrAlSiNAl/WC-Co interface models had the highest and lowest interface adhesion work values (4.312 and 2.536 J·m−2), respectively. Thus, the latter model had the weakest interface bonding property. On this basis, rare earth oxides CeO2 and Y2O3 were doped into the Al terminal model (CrAlSiNAl/WC-Co). Then, doping models of CeO2 and Y2O3 doped on the WC/WC, WC/Co, and CrAlSiNAl/WC-Co interfaces were established. The adhesion work value was calculated for the interfaces in each doping model. When CeO2 and Y2O3 were doped in the WC/WC and CrAlSiNAl/WC-Co interfaces, four doping models were constructed, each model contains interfaces withreduced adhesion work values, indicating deteriorated interface bonding properties. When the WC/Co interface was doped with CeO2 and Y2O3, the interface adhesion work values of the two doping models are both increased, and Y2O3 doping improved the bonding properties of the Al terminal model (CrAlSiNAl/WC-Co) more significantly than CeO2 doping. Next, the charge density difference and the average Mulliken bond population were estimated. The WC/WC and CrAlSiNAl/WC-Co interfaces doped with CeO2 or Y2O3, with decreased adhesion work, exhibited low electron cloud superposition and reduced values of charge transfer, average bond population, and interatomic interaction. When the WC/Co interface was doped with CeO2 or Y2O3, superposition of the atomic charge densities of electron clouds was consistently observed at the CrAlSiNAl/WC-Co interface in the CrAlSiNAl/WC/CeO2/Co and CrAlSiNAl/WC/Y2O3/Co models; the atomic interactions were strong, and the interface bonding strength increased. When the WC/Co interface was doped with Y2O3, the superposition of atomic charge densities and the atomic interactions were stronger than for CeO2 doping. In addition, the average Mulliken bond population and the atomic stability were also higher, and the doping effect was better.

Theoretical calculation and experimental investigation on NbC refined by CeAlO3 in hypereutectic Fe–Cr–C–Nb hardfacing alloy

The first-principles and ab initio molecular dynamics simulations revealing the interface energy of the NbC/α-Fe

Dry sliding wear behavior of Fe-Cr-C-B hardfacing alloy modified with nano-CeO2 and its mechanisms of modification

Mechanical Properties and Chemical Bonding Transitions of Nb/NbC and Α-Fe/nbc Interfaces in Fe-Nb-C Composites

First-principles study on the interfacial electronic structure and analysis of the bonding properties of NbC/Fe composites

Investigation of Al/CeO2 interfacial relationships for epitaxial growth of Al on CeO2 substrates: first-principles calculation

First-Principles Calculation of Nb2AlC/Nb Interfaces

A novel approach to regulate the microstructure of laser-clad FeCrNiMnAl high entropy alloy via CeO 2 nanoparticles

Microstructures and mechanical properties of in-situ FeCrNiCu high entropy alloy matrix composites reinforced with NbC particles

Microscopic mechanism of the effect of Nb and Cr co-doping on the strength and ductility of Ti2AlC/Ti3Al coherent interface

Effects of RE (Nd, Ce, Y, La) on TiC(100)/Fe(110) interface based on first-principles calculations

Effects of NbC addition on mechanical and tribological properties of AlCrFeNi medium-entropy alloy

Thermal/kinetic study of the formation mechanism of NbC-Fe composite layer on the surface of GCr15 prepared by hot pressure diffusion

Microscopic and macroscopic interfacial studies of NbC reinforcement layer on GCr15 bearing steel surface prepared by in-situ reaction method

Orientation relationships and interface structure between Al11Ce3 and Al in Al–Ce eutectic

Achieving low wear in a complex concentrated alloy CrFeNiNb with multi-phase hierarchical microstructure

Energy for the Interface System of (nb, Mo)C/γ-Fe

Wear Properties of Spark Plasma-Sintered AlCoCrFeNi2.1 Eutectic High Entropy Alloy with NbC Additions

Refinement of Microstructure and Enhancement of Wear Resistance of Ni–Cr Cast Iron by NbC

Preparation of hypereutectic-eutectic-hypoeutectic gradient high-entropy alloy coating by in-situ interfacial reaction between Nb and FeCoCrNi

Interface Bonding Properties of CrAlSiN-Coated Cemented Carbides Doped with CeO2 and Y2O3 Rare Earth Oxides