Abstract:In this study, a micro/nano NbC reinforcement layer was prepared on a bearing steel surface by in-situ reaction method using GCr15 bearing steel and high purity niobium plate as raw materials. The rapid diffusion of C, strong carbide formation of Nb, and both melting and mass transfer of the matrix at certain temperatures easily controlled the gradient structure in the reinforcement layer. X-rays diffraction and X-ray photoelectron spectroscopy data revealed the presence of NbC, Fe3C, α-Fe, and Cr7C3 as the main phases in the reinforcement layer. The reinforcement layer can be divided into dense and gradient layers. SEM determined the volume fraction of NbC ceramic particles in the dense layer above 90%, with structure morphology close to that of a completely dense ceramic structure. The gradient layer was composed of two long-strip structures arranged alternately, with structure I consisting of dispersed NbC ceramic particles and structure II containing NbC ceramic particles embedded in the steel matrix. At the microscopic phase interface, the enhanced phase NbC particles were in direct contact with Fe3C without producing other transition phases, and NbC/Fe3C interface presented a non-coherent interface. The macroscopic interface characterized by Electron backscatter diffraction (EBSD) analysis showed consistent crystal orientation characteristics of NbC grains in the reinforcement layer. Also, the reinforcement layer was closely combined with the steel matrix without impurity holes. The macroscopic interfacial bonding strength displayed load scoring values from 0N to 100N without serious deformation failure behavior of the reinforcement layer.

Thermal/kinetic study of the formation mechanism of NbC-Fe composite layer on the surface of GCr15 prepared by hot pressure diffusion

Microscopic and macroscopic interfacial studies of NbC reinforcement layer on GCr15 bearing steel surface prepared by in-situ reaction method

Analysis on Reaction Process and Thermo-dynamics of In-situ NbC/Fe Composite

Growth Kinetics of In Situ Fabricated Dense NbC Coatings on Gray Cast Iron

The investigation on the fabrication and microstructure of NbTi-(NbTi)C Fe-based composite

Study on microstructure and bending properties of NbC/Fe cluster-reinforced steel-based laminated composite

Mechanical Properties and Tribological Behavior of in Situ NbC/Fe Surface Composites

Mechanical Properties and Chemical Bonding Transitions of Nb/NbC and Α-Fe/nbc Interfaces in Fe-Nb-C Composites

Preparation and Performance of a Cr/CrN/TiAlCN Composite Coating on a GCr15 Bearing Steel Surface

TEM characterization and reaction mechanism of composite coating fabricated by plasma spraying Nb–SiC composite powder

Effect of in Situ NbC on Microstructure and Wear Properties of Laser Cladding Co-Based Coatings

Growth kinetics of WC-Fe layer formed at the surface iron during solid-phase diffusion

Microstructure and bond strength of niobium carbide coating on GCr15 prepared by in-situ hot press sintering

Bonding properties and corrosion resistance of TaC-Fe enhanced layer on GCr15 surface prepared by in-situ hot pressing

Effects of NbC content on microstructural evolution and mechanical properties of laser cladded Fe50Mn30Co10Cr10-xNbC composite coatings

Synthesis of nanocrystalline intermetallic layer by mechanical attrition

Mechanical Properties and Formation Mechanism of Surface Hard Nanocrystalline Carbon Diffusion Layer on 18Cr2Ni4WA Steel Induced by Supersonic Fine Particle Bombarding

Microstructures and mechanical properties of in-situ FeCrNiCu high entropy alloy matrix composites reinforced with NbC particles

Gradually varying mechanical properties of in situ synthesized NbC–Fe-graded composite coating

Study on the Interface Microstructure of TaC/GCr15 Steel Surface Reinforced Layer Formed by In-Situ Reaction

Microstructure and property of laser clad Fe-based composite layer containing Nb and B4C powders