Abstract:Supercritical carbon dioxide is widely used in power plant and refrigeration system as working fluid. In this paper, a novel combined cooling and power system consists of supercritical carbon dioxide recompression Brayton cycle and transcritical carbon dioxide refrigeration cycle is proposed. In the novel system, the working fluid through the recompressor in supercritical carbon dioxide recompression Brayton cycle is partially replaced by the refrigeration compressor outlet working fluid in transcritical carbon dioxide refrigeration cycle. Mathematical models are established to simulate the combined system under steady-state conditions and the simulated results show that the reactor dominates the exergy destruction followed by the cooler and high temperature recuperator. Effects of five parameters, including turbine discharge pressure, cooler outlet temperature, evaporation temperature, cooling capacity and mass flow fraction are evaluated. The performances of the proposed combined system and the separation system are optimized and then compared from the perspective of thermodynamics. The calculated results show that the combined system's comparative advantage over separation system will increase with increasing cooling capacity and decreasing evaporation temperature. The exergy efficiency of combined system is up to 2.45% and 5.87% higher than separation system when evaporation temperature is 273.15 K and 253.15 K, respectively. In order to balance the contradiction between the investment and system performance, the multi-objective optimization is conducted with exergy efficiency (to be maximized) and annual cost per heat consumption (to be minimized) as objective functions at different evaporation temperature. Non-dominated sorting generic algorithm-II is employed and Pareto frontier solution for the proposed system is given. Suggestions for engineering practice are provided based on the distributions of some key parameters on Pareto frontier solution.

Assessment on energy and exergy of combined supercritical CO2 Brayton cycles with sizing printed-circuit-heat-exchangers

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Experimental and Numerical Study on Thermal Hydraulic Performance of Trapezoidal Printed Circuit Heat Exchanger for Supercritical CO2 Brayton Cycle

Proposal and Assessment of a Combined Cooling and Power System Based on the Regenerative Supercritical Carbon Dioxide Brayton Cycle Integrated with an Absorption Refrigeration Cycle for Engine Waste Heat Recovery

Performance Analysis of Heat Exchangers and Integrated Supercritical CO2 Brayton Cycle for Varying Heat Carrier, Cooling and Working Fluid Flow Rates

Multi-objective Optimization of Combined Cooling, Heating, and Power Systems with Supercritical CO2 Recompression Brayton Cycle

Performance Investigation and Precooler Design of a Coupled Supercritical CO2-based Mixture Brayton Cycle with Absorption Refrigeration Cycle

Heat Recuperation for the Self-Condensing CO2 Transcritical Power Cycle

Thermodynamic Analysis for a Novel Combined Power and Refrigeration Cycle Using Trans-Critical CO2

Thermo-economic Analysis and Optimization of a Novel Carbon Dioxide Based Combined Cooling and Power System

Thermodynamic Analysis and Comparison Study of Two Novel Combined Cooling and Power Systems with Separators Using CO2-based Mixture for Low Grade Heat Source Recovery

Exergy and Exergoeconomic Analyses of A Supercritical Co2 Cycle for A Cogeneration Application

Thermal and Mechanical Performance of a Hybrid Printed Circuit Heat Exchanger Used for Supercritical Carbon Dioxide Brayton Cycle

Development and performance assessment of a novel combined power system integrating a supercritical carbon dioxide Brayton cycle with an absorption heat transformer

Thermodynamic Optimization on Supercritical Carbon Dioxide Brayton Cycles to Achieve Combined Heat and Power Generation

Performance investigation and precooler design of a coupled supercritical CO 2 -based mixture Brayton cycle with absorption refrigeration cycle

Thermodynamic Analysis for Supercritical Carbon Dioxide Brayton Cycle by Considering Both Thermal Efficiency and Cooler Area

Thermal Evaluation of Heat Exchanger and a Dry-Cooled Supercritical CO2 Mixture Brayton Cycle Based on Three-Dimensional and One-Dimensional Models: Key Factors and Potential Applications

Thermal evaluation of heat exchanger and a dry-cooled supercritical CO 2 mixture Brayton cycle based on three-dimensional and one-dimensional models: Key factors and potential applications

Thermo-economic comparative study and Multi-objective optimization of supercritical CO2-based mixtures Brayton cycle combined with absorption refrigeration cycle

Thermodynamic evaluation and optimization of supercritical CO 2 Brayton cycle considering recuperator types and designs