Abstract:In view of the decreasing trend of column widths in steel residential buildings, a new type of concrete filled rectangular steel tubular column-H-section steel beam connections with external stiffeners is proposed. The diaphragm is removed in this connection. Pseudo-static tests of seven new joint specimens were carried out. The test parameters were the section of the steel beam and the thickness and the height of the long side of the external stiffeners. The failure modes, hysteretic curves, skeleton curves, strength, stiffness degradation, strength degradation, ductility and energy dissipation capacity of the joints were studied. The test results show that there were three failure modes of this new joint, namely, tensile failure of beam flange, weld failure between beam flange and external stiffener, and column wall failure near the external stiffener. The ductility coefficient was 2.17 to 3.67, the equivalent viscous damping coefficient was 0.2 to 0.3, and the average drift ratio was 1/49. The seismic performance of the joint met the requirements of strong joints and weak members. Increasing the thickness or the height of the long side of the external stiffeners can increase the strengths of the joints. The premature cracking of the beam flange, the welding seam between beam flange and external stiffener, or the column wall will reduce the ductility and energy dissipation capacity of the joints. It is proposed that the connection coefficient should be 1.4 when checking the ultimate strength of the column wall and joint weld. The strengthening or weakening measures on the flange at the beam ends can be taken to ensure that the new joints have a sufficient plastic deformation capacity.

Hysteretic model and numerical simulation method of T-shaped SRC column–steel beam joints

Improvement of hysteretic constitutive model for reinforcements considering buckling

Nonlinear Finite-Element Analysis of the Seismic Behavior of RC Column–Steel Beam Connections with Shear Failure Mode

A Ductility-Centred Analytical Model for Axially Restrained Double-Span Steel Beam Systems Subjected to Sudden Columns Loss

A Multi-Spring Component Modelling Approach for T-Stub Connections

A Simplified Analytical Model for U-shaped Steel Dampers Considering Horizontal Bidirectional Deformation

EXPERIMENTAL STUDY ON THE SEISMIC BEHAVIOR OF CFST RECTANGULAR COLUMN TO H-SECTION STEEL BEAM CONNECTIONS WITH EXTERNAL STIFFENERS

Experimental Study on Reduced I-beam to CFRST Column Joints under Cyclic Loading

Hysteretic behavior of GFRP retrofitted RC bridge short columns

Numerical Studies on Full-Scale Steel Columns under Complex Seismic Loading

Development of a numerical model for RC columns considering seismic dynamic effect and different failure modes

NUMERICAL SIMULATION FOR THE HYSTERESIS BEHAVIOR OF RC COLUMNS UNDER CYCLIC LOADS

Research on Hysteretic Model of Frame Structures of Steel Reinforced Concrete Beams and Angle-Steel Concrete Columns

Parameter optimization for Pivot hysteresis model for reinforced concrete columns with different failure modes

Hysteresis Relationship in Concrete Filled Steel Tubular Columns and Steel Beam Planar Frames

Adaptive hysteretic model for reinforced concrete columns including variations in axial force and shear span length

Non-Linear Numerical Simulation on Mechanical Behaviour of Steel Reinforced Concrete (SRC) Columns

Experimental and numerical investigation of the hysteretic behavior of reinforced concrete column-steel beam interior joints under low seismic intensity levels

Nonlinear Model for Seismic Analysis of Steel-Concrete Composite Beams

Experimental investigation on joints between steel-reinforced concrete T-shaped column and reinforced concrete beam under bidirectional low-cyclic reversed loading

EXPERIMENTAL RESEARCH AND NONLINEAR FINITE ELEMENT ANALYSIS ON NEW TYPE JOINT BETWEEN COLUMN AND STEEL BEAM OF CONCRETE-FILLED RECTANGULAR STEEL TUBULAR