Abstract:In order to study the anti-corona performance of the stator end winding of a large generator, this paper takes the stator end winding of an 18kV hydroelectric generator as the research object to conduct simulation analysis. Firstly, three out-of-phase stator winding models were constructed based on two possible anti-corona structures that may be used for the stator bar of the generator. Then, finite element electric field simulation analysis is conducted using COMSOL Multiphysics software. The research results indicate that a sudden change in the potential of the stator winding at the low resistance and high resistance overlap points of the high-voltage bar as well as at the binding position of the diagonal edge of the bar occurs. The maximum value of the winding air gap field strength occurs in the air domain between the medium and high resistance overlap points of the two stator bars, and the maximum value of the loss distribution occurs at the low resistance and high resistance overlap areas of the highvoltage stator bar. The simulation results show that as the excitation voltage increases, the distribution of potential, electric field, and loss gradually increases. Moreover, under different assessment voltages, all three winding models meet the requirements for the anti-corona performance of the generator stator winding. This indicates that the mixed use of different anticorona structures has a relatively small impact on the distribution of electric field at the end of the stator winding. In addition, in the actual production, attention should be paid to the anti-corona treatment in the area with concentrated electric field distribution, so as to avoid corona discharge, ablation and even winding gap breakdown during the operation of the generator.

Impact of Stator Interturn Short Circuit Position on End Winding Vibration in Synchronous Generators

Transient Analysis Of Synchronous Generator With Stator Winding Faults Based On Starting Process

A comprehensive study on stator vibrations in synchronous generators considering both single and combined SAGE cases

Impact of Static Air-Gap Eccentricity on Thermal Responses of Stator Winding Insulation in Synchronous Generators

Comprehensive Investigation of Winding Mechanical Properties in Generators under RISC: Impact of Position, Degree, and Eccentricity

Impact of Radial Air-Gap Eccentricity on Stator End Winding Vibration Characteristics in DFIG

Investigation of SISC on Electromechanical Characteristics of External Rotor Permanent Magnet Generator

3D finite element study of transient electromagnetic forces acting on the stator end-windings of a large turbo-generator

Electromagnetic Torque of Synchronous Generator with Inter-turn Short Circuit in the Field Winding

An Equivalent Model for Sub-Synchronous Oscillation Analysis in Direct-Drive Wind Farms with VSC-HVDC Systems

Analysis of Excitation Winding Induced EMF in Non-Overlapped Stator Wound Field Synchronous Machines

Effects of Stator Winding Configurations on Steady-state Currents Characteristics of Synchronous Generator With Inter-turn Short Circuits of Field Windings

Numerical Modeling, Electrical Characteristics Analysis and Experimental Validation of Severe Inter-Turn Short Circuit Fault Conditions on Stator Winding in DFIG of Wind Turbines

Impact of Synchronous Condenser on Sub/Super-Synchronous Oscillations in Wind Farms

Simulation Research on Inter-Turn Short Circuits of Field Windings in Synchronous Machines

Electric Field Simulation Analysis on the End of Stator Winding for Large Generators

Influence of Inter-turn Short-Circuit Fault Considering Loop Current on Electromagnetic Field of High-Speed Permanent Magnet Generator with Gramme Ring Windings

Theoretical Analysis and Calculation Model of the Electromagnetic Torque of Nonsalient-Pole Synchronous Machines With Interturn Short Circuit in Field Windings

Analysis and Detection of Inter-Turn Short-Circuit Fault Through Extended Self-Commissioning

Math Model and Fault Characteristics of Field Winding Inter-turn Short Circuit of Synchronous Generator

Impact of DFIG-Based WTs on Subsynchronous Oscillation Damping of SG Based on the Net Electrical Damping Method