Surface characterization of metal oxides-supported activated carbon fiber catalysts for simultaneous catalytic hydrolysis of carbonyl sulfide and carbon disulfide

Kunlin Li,Chi Wang,Ping Ning,Kai Li,Xin Sun,Xin Song,Yi Mei

DOI: https://doi.org/10.1016/j.jes.2020.03.019

IF: 6.9

2020-10-01

Journal of Environmental Sciences

Abstract:The sol-gel method was used to synthesize a series of metal oxides-supported activated carbon fiber (ACF) and the simultaneous catalytic hydrolysis activity of carbonyl sulfide (COS) and carbon disulfide (CS₂) at relatively low temperatures of 60°C was tested. The effects of preparation conditions on the catalyst properties were investigated, including the kinds and amount of metal oxides and calcination temperatures. The activity tests indicated that catalysts with 5 wt.% Ni after calcining at 400°C (Ni(5)/ACF(400)) had the best performance for the simultaneous catalytic hydrolysis of COS and CS₂. The surface and structure properties of prepared ACF were characterized by scanning electron microscope-energy disperse spectroscopy (SEM-EDS), Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD), carbon dioxide-temperature programmed desorption (CO₂-TPD) and diffuse reflectance Fourier transform infrared reflection (DRFTIR). And the metal cation defects were researched by electron paramagnetic resonance (EPR) method. The characterization results showed that the supporting of Ni on the ACF made the ACF catalyst show alkaline and increased the specific surface area and the number of micropores, then improved catalytic hydrolysis activity. The DRFTIR results revealed that -OH species could facilitate the hydrolysis of COS and CS₂; -COO and -C-O species could facilitate the oxidation of catalytic hydrolysate H₂S. And the EPR results showed that high calcination temperature conditions provide more active reaction center for the COS and CS₂ adsorption.

environmental sciences

What problem does this paper attempt to address?

### Problems the Paper Aims to Solve

This paper aims to study the simultaneous catalytic hydrolysis performance of carbonyl sulfide (COS) and carbon disulfide (CS₂) using activated carbon fiber (ACF) catalysts loaded with metal oxides at a lower temperature (60°C). Specifically, the paper explores the following points:

1. **Influence of Catalyst Preparation Conditions**:
- Types and contents of metal oxides.
- Calcination temperature.

2. **Catalyst Characterization**:
- Characterization using methods such as Scanning Electron Microscopy-Energy Dispersive Spectroscopy (SEM-EDS), BET method, X-ray Diffraction (XRD), Carbon Dioxide-Temperature Programmed Desorption (CO₂-TPD), and Diffuse Reflectance Fourier Transform Infrared Spectroscopy (DRFTIR).
- Analysis of metal cation defects using Electron Paramagnetic Resonance (EPR) technology.

3. **Catalytic Activity Testing**:
- Conducting COS and CS₂ removal experiments in a fixed-bed reactor and evaluating the catalytic hydrolysis efficiency of the catalyst under different conditions.

Through these studies, the paper aims to find the optimal catalyst formulation and preparation conditions to achieve efficient removal of COS and CS₂. Specifically, the study found that the Ni(5)/ACF(400) catalyst exhibited the best catalytic hydrolysis performance at 60°C.