Abstract:Highly efficient hydrogen production from biomass can be realized by using catalysts in the reaction process under more mild hydrothermal conditions. Among various catalysts, Ni based catalysts are considered as the most promising catalyst for hydrogen production due to its low cost and good catalytic activity. In order to solve the problem of catalyst deactivation caused by carbon deposion at the acid site of Ni/Al2O3,the additives were studied to modify the Ni based catalysts loaded on Al2O3 in our research group. Cu, Co, Ce and Mg were chosed as additive and bimetal Ni-M or complex oxide catalysts were prepared by co-impregnation, impregnation by step, and co-precipitation, etc. The results show that the introduction of metal Ce can effectively improve the catalytic activity of hydrogen production, and the resistance of carbon deposition can also be improved, indicating that metal Ce is a suitable additive. Mg additive can restrain the formation of crystalline carbon on the surface of Ni-Al catalyst. Much lower heat-treating temperature or impregnation by step in preparation can obtain more effective active sites for Ni-Mg-Al catalyst. Moreover, Mg additive can improve the catalytic activity and hydrothermal stability of Ni-Al catalyst. As to the Ni catalyst loaded on rutile TiO2 prepared by sol-gel process, Ni crystals with much higher dispersity can be achieved by lowering the heat-treating temperature, which provide more active sites and promote the C-C bond breaking of biomass under hydrothermal conditions as well as water gas shift reaction and methanation reaction, thus improving the conversion efficiency of biomass. The thermodynamic analysis was performed with Aspen Plus V7.3.2. The thermodynamic models was built using the P-R equation of state and the MHV2 mixing rule to predict the gas yields in the hydrothermal gasification process. Hydrothermal gasification of biomass and its model compounds was theoretically analyzed. The equilibrium state of hydrothermal gasification reaction was obtained by calculating the gas production under certain temperature and pressure, which points out the direction and limitation of hydrothermal gasification reaction.

Thermal conversion of organic furniture waste to hydrogen fuel via catalytic air gasification over monolithic spinel-type oxide-supported nickel catalysts

Thermocatalytic conversion of wood-plastic composite over HZSM-5 catalysts

Enhanced H2 Production from Municipal Solid Waste Gasification Using Ni–CaO–TiO2 Bifunctional Catalyst Prepared by Dc Arc Plasma Melting

Catalytic pyrolysis of film waste over Co/Ni pillared montmorillonites towards H2 production

Hydrogen Production by Hydrothermal Gasification of Biomass：Catalysts and Thermodynamic Analysis

H2-rich gas production from wood biomass air-steam gasification over a multifunctional Ni1.5Ca4.0Mn1.0Ox catalyst derived from biomaterial

Optimization of Charcoal Production Process from Woody Biomass Waste: Effect of Ni-Containing Catalysts on Pyrolysis Vapors

Preparation of Hydrogen via Catalytic Gasification of Residues from Biomass Hydrolysis with a Novel High Strength Catalyst

High-yield H2 production from polypropylene through pyrolysis-catalytic reforming over activated carbon based nickel catalyst

Green and effective catalytic hydroconversion of an extractable portion from an oil sludge to clean jet and diesel fuels over a mesoporous Y zeolite-supported nickel catalyst

Hydrogen-Rich Gas Production from Two-Stage Catalytic Pyrolysis of Pine Sawdust with Nano-NiO/Al2O3 Catalyst

Catalytic Hydropyrolysis of Biomass over NiMo Bimetallic Carbon-Based Catalysts

Enhancement of H 2 production via catalytic steam gasification of food waste as feedstock and its ash as a support and promoter for Ni catalyst

Production of Pure Hydrogen through Thermocatalytic Methane Decomposition Using NiO-MgO Catalysts Promoted by Chromium and Copper Prepared via Mechanochemical Method

Syngas Production from Phenolic Pollutants via A Series of Hydroxylation, Ring Cleavage, and Aqueous-Phase Reforming Catalyzed by Hydrotalcite-Supported Fe-Mn-Ni Alloy

Catalytic Co‐pyrolysis of Packaging Plastic and Wood Waste to Achieve H2 Rich Syngas

Sewage sludge steam gasification over bimetallic mesoporous Al-MCM48 catalysts for efficient hydrogen generation

Fabrication of NiZn Bimetallic Oxides Catalysts Supported on Carbon Black Waste for Catalytic Pyrolysis of Fatty Acid

Two-Stage Gasification of Sewage Sludge for Enhanced Hydrogen Production: Alkaline Pyrolysis Coupled with Catalytic Reforming Using Waste-Supported Ni Catalysts

Valorization of furniture industry-processed residue via catalytic pyrolysis with methane

Hydrogen-rich syngas from wet municipal solid waste gasification using Ni/Waste marble powder catalyst promoted by transition metals