Abstract:Combined use of thermal analysis techniques can realize complementarity of different characterization methods. Comprehensive thermal analysis with both thermogravimetric analysis and differential thermal analysis (TG/DTA) can measure not only mass change of a sample but also its temperature change during programmed heating-induced reaction or phase transition processes, thereby obtaining multiaspect thermal information of the material such as dehydration, structural decomposition, phase change and thermal stability. This study proposes and develops a MEMS chip-based TG/DTA microsystem that integrates both programmed heating and detecting elements into a TG chip and a DTA chip to enable the microinstrument performing TG/DTA joint characterization under microscope observation. The TG chip contains a self-heating resonant microcantilever to measure heating-induced mass change of a sample and the DTA chip is with a microheater and a temperature-detecting thermopile integrated on a suspended thermal-insulating diaphragm. Only nanogram and microgram-level samples are needed for the TG and DTA chips, thereby achieving safe measurement to energetic materials such as strong oxidants. The chip-based microinstrument surpasses the state-of-the-art commercial TG/DTA instruments that have, in the long term, suffered from large sample-amount (milligram level) requirements and have been unable to measure energetic materials. Compared with commercial instruments, the chip-based microinstrument is advantageous given its more accurate analysis, much higher heating rate, much smaller instrument volume and much lower power consumption, etc. The microinstrument has been fabricated by using wafer-level MEMS techniques. Testing results show that the mass-detection sensitivity of the TG-chip is as high as 0.45 Hz/pg in air and the temperature sensitivity of the DTA chip achieves 2.9 mV/K under the high heating rate of 25 °C/s. The strong oxidant of KMnO4 is analyzed with the TG/DTA joint characterization under microscopic observation. At the same time as microscope observation of the thermal decomposition phenomena, two-step thermal decomposition process of KMnO4 is identified and the thermal decomposition temperatures are obtained. The TG/DTA microinstrument is promising to be applied for study of various materials.

QEchemMEMS – A Working Electrode With High-resolution Temperature Sensing for Studying Electrochemical Heat Management Systems

Ultrasensitive electrolyte-assisted temperature sensor

Design of Thermal Liquid Flow Microsensor

Integrated interdigital electrode and thermal resistance micro-sensors for electric vehicle battery coolant conductivity high-precision measurement

Real-Time Data Acquisition Inside High-Pressure PEM Water Electrolyzer

Preparation and Performance Evaluation of a Miniature High-Temperature Heat Flux Sensor With Centralized Thermal Insulation Structure

Precise nanoscale temperature mapping in operational microelectronic devices by use of a phase change material

Study on the Characteristics of Thermo-Electrodes of Various Deposition Parameters for the Flexible Temperature Sensor.

THERMOELECTRIC MONITORING OF THERMAL RESISTANCE IN ELECTRONIC SYSTEMS

An Integrated Miniature Conductivity And Temperature Sensor Chip With Open-Cell Annular Electrode

Quantifying Real-Time Sample Temperature Under the Gas Environment in the Transmission Electron Microscope Using a Novel MEMS Heater

Real-Time Monitoring of the Temperature, Flow, and Pressure Inside High-Temperature Proton Exchange Membrane Fuel Cells

Hardware/Software Data Acquisition System for Real Time Cell Temperature Monitoring in Air-Cooled Polymer Electrolyte Fuel Cells

Flexible Seven-in-One Microsensor Embedded in High-Pressure Proton Exchange Membrane Water Electrolyzer for Real-Time Microscopic Monitoring

Cholesterol oxidase-immobilized MXene/sodium alginate/silica@n-docosane hierarchical microcapsules for ultrasensitive electrochemical biosensing detection of cholesterol

Chip-Based MEMS Platform for Thermogravimetric/Differential Thermal Analysis (TG/DTA) Joint Characterization of Materials

Hot-Tip Scanning Electrochemical Microscopy: Theory and Experiments Under Positive and Negative Feedback Conditions

Big MEMS for Thermal Measurement

Alternate Hot and Cold Electrodes

A Solid Electrolyte RHE for Electrode Diagnosis of Proton Exchange Membrane Water Electrolyzers

A High-Sensitivity Microfluidic Chip Calorimeter for Biochemical Reaction Monitoring Applications