Abstract:In this study, we developed a prototype animal PET by applying several novel technologies to use solid-state photomultiplier (SSPM) arrays to measure the depth of interaction (DOI) and improve imaging performance. Each PET detector has an 8 × 8 array of about 1.9 × 1.9 × 30.0 mm(3) lutetium-yttrium-oxyorthosilicate scintillators, with each end optically connected to an SSPM array (16 channels in a 4 × 4 matrix) through a light guide to enable continuous DOI measurement. Each SSPM has an active area of about 3 × 3 mm(2), and its output is read by a custom-developed application-specific integrated circuit to directly convert analogue signals to digital timing pulses that encode the interaction information. These pulses are transferred to and are decoded by a field-programmable gate array-based time-to-digital convertor for coincident event selection and data acquisition. The independent readout of each SSPM and the parallel signal process can significantly improve the signal-to-noise ratio and enable the use of flexible algorithms for different data processes. The prototype PET consists of two rotating detector panels on a portable gantry with four detectors in each panel to provide 16 mm axial and variable transaxial field-of-view (FOV) sizes. List-mode ordered subset expectation maximization image reconstruction was implemented. The measured mean energy, coincidence timing and DOI resolution for a crystal were about 17.6%, 2.8 ns and 5.6 mm, respectively. The measured transaxial resolutions at the center of the FOV were 2.0 mm and 2.3 mm for images reconstructed with and without DOI, respectively. In addition, the resolutions across the FOV with DOI were substantially better than those without DOI. The quality of PET images of both a hot-rod phantom and mouse acquired with DOI was much higher than that of images obtained without DOI. This study demonstrates that SSPM arrays and advanced readout/processing electronics can be used to develop a practical DOI-measureable PET scanner.

Prototype design of singles processing unit for the small animal PET

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A Design Implementation of the Central Process Module for an In-Beam PET in HICTD

Initial Testing of Singles Processing Unit for the Small Animal PET

Evaluation of a Prototype of New Position-Sensitive Detector for a Small Animal PET System

Development and Performance Evaluation of a High-Sensitivity Positron Emission Tomography Scanner Dedicated for Small-Animal Imaging

Performance Evaluation of S-PET, a Compact, High Sensitivity and High Resolution Small Animal PET Prototype

A High-Sensitivity Small-Animal Pet Scanner: Development and Initial Performance Measurements

Development of a Prototype PET Scanner with Depth-of-interaction Measurement Using Solid-State Photomultiplier Arrays and Parallel Readout Electronics.

Testing of Singles Processing Unit for a Brain PET

Validation of the design of a high-sensitivity and high-resolution PET system for a preclinical PET/EPR hybrid scanner

Design and Evaluation of a Prototype Portable Panel PET Imaging System

Performance Evaluation of A Compact Pet/Spect/Ct Tri-Modality System for Small Animal Imaging Applications

Design and performance of SIAT aPET: a uniform high-resolution small animal PET scanner using dual-ended readout detectors

Design of the Time Measurement Circuit, Single Data Frame Sorting, and Packaging Logic of a TOF PET System

Precise imaging of small animals using a dual-head microPET scanner

An Investigation of an Application Specific PET Prototype with Inhomogeneous-Energy Resolution Detectors

Development of a SiPM-based PET imaging system for small animals

Evaluation of a PET Detector for a Next Generation Preclinical PET/EPRI

Feasibility Study of a Small Animal PET Insert Based on a Single LYSO Monolithic Tube

Development and Initial Performance Measurements of Trans-PET BioCaliburn SH1.0