Abstract:In order to provide a basis for the thermal control of the focusing telescope and the optimal design of the support structure, the three-dimensional full-size modeling and finite element analysis of the follow-up X-ray telescope's mirrors group in the Einstein probe project are carried out. The influence of axial and radial temperature gradients, as well as the supported and unsupported structures on the deformation of the mirrors group is studied. The relationship between the surface error and the temperature difference is explored. The results show that the relation between the surface error and the mirrors' radius for unsupported structures under the axial temperature gradient is close to the linear relation, while the relation under the radial temperature gradient is close to the piecewise quadratic relation. When the support structure is thermally deformed, the surface error corresponding to that occurs in the mirrors group. That transforms the in-phase roundness error into the out-of-phase roundness error, and increases the Peak-to-Valley value of the overall surface error of the mirrors group by 32.25 similar to 123.01 %, and the Root-Mean-Square value by 4.13% similar to 5.14 %. For supported structures, the thermally induced surface error is proportional to the temperature difference. When the temperature difference increases by VC , the Peak-to-Valley value and Root-Mean-Square value of surface error increase by 7.76 mu m and 1.12 mu m respectively under the axial temperature gradient, while 9.67 mu m and 1.60 um, respectively, under radial temperature gradient. The thermal-induced surface error of the focusing mirrors has a linear relationship with the mirrors size and temperature difference under certain conditions, and is significantly affected by the deformation of the support structure.

Research on accurate non-contact temperature measurement method for telescope mirror

Non-uniform temperature field measurement and simulation of a radio telescope's main reflector under solar radiation

Research on Quartz Flat Mirror'S Thermal Deformation under the Condition of Non Uniform Heating

Thermal control of primary mirror of Space Solar Telescope

Numerical Study on Thermal Deformation of Wolter-I Focusing Telescope

Polarized-Light Difference Method and Equipment for High-Precisely Measuring Star Sensor Bracket Thermal Deformation Based on Laser Autocollimation

Optimization of Thermal Control Design for Aerial Reflective Opto-Mechanical Structure

Distance Measurement for Rotation Center to Measurement Table Using Triangulation Method

Support Mechanism Design of Large Aperture Reflective Mirror for Large Temperature Variations

Simulation and an Experimental Study on the Optical Performance of a Wolter-I Focusing Mirror Based on a 3D Ray Tracing Algorithm.

Numerical simulation and analysis of X-ray focusing telescope in mounting process

Non-contact rotation angle measurement system for scanning mirrors

Design and Optimization for Mounting Primary Mirror with Reduced Sensitivity to Temperature Change in an Aerial Optoelectronic Sensor

Figure Error Measurement Method of Cylindrical Reflection Mirror for Conic Approximate Wolter-I X-ray Type Telescope

Non-Contact Temperature Measurement by Laser Technology

A Comparative Study of the Thermal Performance of Primary Mirror at the Four Typical Sites

Engineering Design of an Active–Passive Combined Thermal Control Technology for an Aerial Optoelectronic Platform

Cooling air flow field in the primary mirror temperature control system of a solar telescope

Error Analysis and Reflection Correction for Radiation Temperature Measurements at High Background Temperatures

Quantitative Evaluation on Thermal Seeing Induced 2m Ring Solar Telescope.