Abstract:Ultra-high performance concrete (UHPC) is characterized by its ultra-high strength and durability, making it suitable for use in large-span bridges, super high-rise buildings, and other special structures. These types of structures often have high requirements for crack control, making the exploration of UHPC's fracture mechanics properties of significant importance. Therefore, this paper sets up four steel fiber contents (0%, 0.6%, 1.2% and 1.8%) and four strain rates (10-5/s, 10-4/s, 10-3/s and 10-2/s), totaling 16 working conditions. The hydraulic servo system combined with digital image correlation (DIC) technology was used to conduct fracture mechanics tests on UHPC three-point bending beams. The test results show that the unstable fracture load of UHPC increases with the increase of strain rate and steel fiber content, and increasing the steel fiber content can enhance the strain rate effect of UHPC to a certain extent. Additionally, combined with the J-criterion model, this study proposed a dynamic criterion for the unstable fracture load of UHPC considering the influence of steel fiber content. The initial fracture toughness, unstable fracture toughness, and fracture energy of UHPC are significantly more affected by steel fiber content than by strain rate. Through DIC technology, the analysis of UHPC crack propagation shows that UHPC without steel fibers experiences rapid crack expansion in the Pre-90% to Peak stage, with less influence from the strain rate. However, UHPC with steel fibers exhibits a more uniform crack growth rate, with the crack emergence phase gradually lagging as the strain rate increases. For UHPC without steel fibers, the crack opening displacement (COD) at the unstable fracture load point surges suddenly, while the COD development in UHPC with steel fibers is slower. At lower strain rates, an increase in steel fiber content leads to an earlier sudden increase phase in UHPC's COD; at higher strain rates, the influence of steel fiber content on the sudden increase phase of UHPC's COD is more scattered. The research results of this paper provide a theoretical basis for the calculation and analysis of the dynamic response of UHPC structures under seismic loads.

Thermal-dependent brittleness effect of ultra-high performance concrete exposed to cryogenic flexural loads by acoustic emission evaluation

Experimental Study on Stress Wave Propagation in Ultra High Toughness Cementitious Composites

The use of AE technique for identifying ductility degradation against cryogenic on flexural performance of UHPC at various temperature conditions

Flexural fatigue behavior of ultra-high performance concrete under low temperatures

Flexural Behavior of Ultra-High-Performance Fiber-Reinforced Concrete Beams after Exposure to High Temperatures

Investigation of Ultrahigh-Performance Concrete Fracture Characteristics with Different Steel Fiber Fractions Based on Acoustic Emission

Failure mechanism of steel fiber pullout in UHPC affected by alternating cryogenic and elevated variation

Acoustic Emission–Based Shear Fracture Characterization of Ultra‐High‐Performance Concrete With Varying Steel Fiber Contents

Systematic studies on behaviors of ultra-high performance concrete subject to freezing and thawing cycles combining DIC technology

Thermal and Mechanical Properties of Ultrahigh Toughness Cementitious Composite with Hybrid PVA and Steel Fibers at Elevated Temperatures

Fracture Characterization of Ultra-High Performance Concrete Notched Beams under the Influence of Different Material Factors Based on Acoustic Emission Technique

Study on the Fracture Mechanical Properties of High Performance Concrete (HPC) with Rapid Cooling after High Temperature

Flexural behaviour and evaluation of ultra-high-performance fibre reinforced concrete beams cured at room temperature

High temperature and freeze-thaw study of strengthened concrete with ultra-high-performance concrete

Experimental Study of Flexural Performance of UHPC-NC Laminated Beams Exposed to Fire

Experimental study on shear performance of ultra-high-performance concrete beams at elevated temperatures

Fracture behavior of ultra‐high performance lightweight concrete: In situ investigations using μ‐CT

Mechanics Behavior of Ultra High Toughness Cementitious Composites after Freezing and Thawing

Uniaxial compression performance and stress–strain constitutive model of the aluminate cement-based UHPC after high temperature

Study on the Dynamic Fracture Mechanical Properties of Ultra High-Performance Concrete under the Influence of Steel Fiber Content

Theoretical and Experimental Research of Ultra-High-Performance Concrete Tensile Behaviour Based on Micro-Analysis