Abstract:The highly reactive chemical nature of aluminum makes it production energy-intensive or essentially impossible to extract alloying elements from Al-based liquids. Using molten salt fluxing and electrolysis processes can effectively refine coarse Al scraps. However, the generation of toxic gases and hazardous dross during these processes can cause significant environmental protection challenges and result in notable social concerns. Therefore, the primary recycling of post-consumer Al in industries currently proceeds mainly in a cascade manner, which is not sustainable when considering the Al cycle trends in the coming decades. Herein, we develop a novel process to separate primary Al from the crystallizing liquid when a constant electromagnetic force (EMF) is applied. Using this technique, we successfully upgraded Al–7mass%Si (hereafter, unless specified otherwise) alloy to approximately Al–3.6%Si in directional solidification. The separation mechanism was discussed in terms of the electrical properties of the respective phases during solidification. Fluid flow simulation results were applied to elucidate the separation behavior in the alloy. The upper and lower limits to separate the crystallizing alloy into an Al-rich and Si-rich areas were determined when the controlling factors were clarified, which made it possible to scale up the present laboratory-based setup to an industrial level. Moreover, the energy consumption of the process was slightly higher than that required for remelting only. Using the EMF technique to separate the crystallizing alloy into Al-rich and Si-rich regions did not produce hazardous dross or toxic gases. This energy-saving and eco-friendly process can provide a breakthrough to overcome the "dead metal" crisis and thus realize sustainability by upgrading recycling of post-consumer hypoeutectic Al–Si casting alloys.

Recovery of aluminum from waste aluminum alloy by low-temperature molten salt electrolysis

Impurity Behavior in Aluminum Extraction by Low-Temperature Molten Salt Electrolysis

Recycling alloy scrap and CO2 by paired molten salt electrolysis

Recycling of Aluminum from Fibre Metal Laminates

Research Progress on Recovery of Aluminum Salt Suldge

Efficient lithium recovery from electrolytic aluminum slag via an environmentally friendly process: Leaching behavior and mechanism

Upgrading recycling of Al–7 wt%Si alloys using electromagnetic force in directional solidification

Research on synergistic disposal and high-value utilization of secondary aluminum dross and spent carbon anode

Molten Salt-Enhanced Production of Hydrogen by Using Skimmed Hot Dross from Aluminum Remelting at High Temperature

Electrodeposition of aluminum on rare earth alloy surface in room temperature molten salts

Study on Recovery of Lithium from Lithium-Containing Aluminum Electrolyte

A solid-state electrolysis process for upcycling aluminium scrap

A novel approach for extracting lithium from overhaul slag by low temperature roasting – water leaching

A novel electrochemical method for the removal of aluminum from ionic rare earth leachate

Recovery of Li from waste Li-containing Al electrolytes with high F and Na contents by using a CaO roasting–water leaching process

A Novel Process for Simultaneous Extraction of Iron, Vanadium, Manganese, Chromium, and Titanium from Vanadium Slag by Molten Salt Electrolysis

Molten-salt enhanced anodic oxidation for upcycling alloy scraps

Recycling of spent refractory materials to produce Al–Si master alloys via the aluminum reduction cell

Preparation of aluminium-magnesium alloys and some valuable salts from used beverage cans

Purification of spent cathode carbon from aluminum electrolysis cells by alkali fusion-acid leaching process