Abstract:Soil nitrogen is the most limiting nutrient affecting plant growth. However, due to poor soil management due to lack of soil health information, high-N fertilizer use increased exponentially. The UN has labeled nitrogen pollution one of the most important pollution issues facing humanity[1]. Not only does it affect life on land and underwater, it is also 300 times more potent at heating the climate than carbon dioxide while remaining active for 100 years in the atmosphere. Currently, soil nitrogen assessment techniques require destructive sampling where a soil core is collected then shipped to a lab to measure nitrogen content. Not only does this technique have high costs, it only measures nitrogen levels at that specific time point. In this work, we utilized commercially available screen printed electrodes (SPE) with a nitrate ionophore for low cost real-time continuous tracking of soil nitrate levels. The ionophore coating utilizes tetradodecylammonium nitrate (TDDA) as the selective reagent as it’s highly specific to nitrate ions. Previous work done using TDDA used open circuit potential (OCP) to measure nitrate concentration. Soil water content, pH, environmental noise, and other ions impact OCP thus making it unreliable for long term continuous measurements. This work utilizes electrochemical impedance spectroscopy (EIS) instead as it is more robust against the previously mentioned parameters. By opting to use a higher frequency of 1 kHz to extract nitrate concentration, we avoid environmental noise that are dominant at lower frequencies. The sensor output was calibrated in three different soil textures from 2 – 512 ppm presented in Fig. 1(a) for Clay soil. Then the sensor accuracy was validated to the gold standard cadmium reduction method presented in Fig. 1(b) showing non-significant differences with one sample only having a *p-value of 0.049. Lastly, the sensor stability was measured for 7 days continuously in soil with a coefficient of variation of 17% which is under the acceptable standard 20%. Figure 1 (a) Calibrated dose response for Clay soil with 50% water content. (b) vaidation of proposed sensor against gold standard in various soil types. (c) longitudinal study showing stablity and consistency of sensor performance in-situ Figure 1

Non-Equilibrium Nitrate Detection in Ionophore-Based Solid-Contact Ion-Selective Electrodes

Nonequilibrium Anion Detection in Solid-Contact Ion-Selective Electrodes

The Use of Ion-Selective Electrodes for Evaluating Residence Time Distributions in Expanded Bed Adsorption Systems

Steady-State and Transient Performance of Ion-Sensitive Electrodes Suitable for Wearable and Implantable Electro-Chemical Sensing

Concurrent measurement of nitrate and ammonium in water and soil samples using ion‐selective electrodes: Tackling sensitivity and precision issues

Novel Experimental Setup for Coulometric Signal Transduction of Ion-Selective Electrodes

Modeling of NO_3~- Ion-Selective Electrode

An efficient sensing system using ion-selective membrane on Ni 2 O 3 /rGO nanocomposite for electrochemical detection of nitrate ions

Amperometric Response of Solid-Contact Ion-Selective Electrodes Utilizing a Two-Compartment Cell and a Redox Couple in Solution

Ion-Selective Detection of Cations and Anions by Using Pulsed Amperometric Two-Electrode System

Regulating the Polypyrrole Ion-Selective Membrane and Au Solid Contact Layer to Improve the Performance of Nitrate All-Solid Ion-Selective Electrodes

Minimalizing Non-point Source Pollution Using a Cooperative Ion-Selective Electrode System for Estimating Nitrate Nitrogen in Soil

An ISE-based On-Site Soil Nitrate Nitrogen Detection System

Deploying Hydrogen Bond Donor/acceptor on Arylethynyl Scaffold II: Urea Based Tripodal Ionophores for Polymeric Membrane Nitrate Selective Electrodes

An Electrochemical Approach to in-Situ Continuous Soil Nitrate Monitoring

Preparation of Nitrate Bilayer Membrane Ion-Selective Electrode Modified by Pericarpium Granati-Derived Biochar and Its Application in Practical Samples

Study of Ion-to-Electron Transducing Layers for the Detection of Nitrate Ions Using FPSX(TDDAN)-Based Ion-Sensitive Electrodes

Recent Advances in Nanomaterial-Based Solid-Contact Ion-Selective Electrodes

Construction of all-solid-state ion-selective sensors using electrolyte-containing polymers

Solid-contact polymeric membrane ion-selective electrodes using a covalent organic framework@reduced graphene oxide composite as ion-to-electron transducer

In-field determination of soil ion content using a handheld device and screen-printed solid-state ion-selective electrodes