Abstract:Ion-selective electrodes (ISE’s) have benefits for solution-phase detection and quantification of ions, such as ease of operation, low cost, and high throughput compared to, e.g., ion chromatography or mass spectrometry methods. ISE devices are traditionally operated under zero-current conditions, where analyte ions passively exchange across a selective membrane barrier, yielding a Nernstian response after equilibration of Coulombic and chemical driving forces across the membrane. However, this passive mode of operation can require long equilibration times and lead to drift, for example due to electrolyte leakage and pH impacting the membrane and reference electrode. In recent years, non-equilibrium detection techniques have been of growing interest, where the ISE signal is obtained under applied electrical signal. However, the majority of this work has been devoted to cation sensing, with relatively few studies examining anion ISEs under active electrical actuation. Agricultural expansion and the corresponding uptick in application of supplemental nitrogen to soil has led to an increased demand for technologies to measure anions like nitrate – both from a production and regulation standpoint. In this work, we employ galvanostatic polarization of solid-contact ISEs as a non-equilibrium nitrate detection method. Our investigation involves coating electrodes with a redox-active charged polymer to act as a transduction layer to convert ionic to electronic signal, followed by solvent casting of a polymeric ion-selective membrane. We examine the impact of repeated rapid charging and discharging ISE electrode stacks on measurement time and stability. We compare the metrics derived from this technique to conventional open-circuit measurements using the same device. We identify benefits for this mode of operation using established nitrate membrane materials (e.g. nitrate ionophore VI membrane cocktail) that address some of the typical limitations of these conventional materials and we discuss opportunities for further refinement.

Steady-State and Transient Performance of Ion-Sensitive Electrodes Suitable for Wearable and Implantable Electro-Chemical Sensing

Modeling Non-Equilibrium Ion-Transport in Ion-Selective-Membrane/Electrolyte Interfaces for Electrochemical Potentiometric Sensors

Nonequilibrium Anion Detection in Solid-Contact Ion-Selective Electrodes

Biocompatible Solid‐State Ion‐Sensitive Organic Electrochemical Transistor for Physiological Multi‐Ions Sensing

All-solid-state Potentiometric Sensor Using Single-Walled Carbon Nanohorns As Transducer

Ionogel Infiltrated Paper As Flexible Electrode for Wearable All-Paper Based Sensors in Active and Passive Modes

A multichannel electrochemical all-solid-state wearable potentiometric sensor for real-time sweat ion monitoring

Non-Equilibrium Nitrate Detection in Ionophore-Based Solid-Contact Ion-Selective Electrodes

Strain-insensitive and multiplexed potentiometric ion sensors via printed PMMA molecular layer

Gradient Porous Graphene-Based Ion-Selective Electrode for Real-Time Monitoring of Sweat Electrolyte

Ion Sensing with Thread-Based Potentiometric Electrodes

Ion sensors based on organic semiconductors acting as quasi-reference electrodes

Microfabricated Ion-Selective Transistors with Fast and Super-Nernstian Response

Ion‐Selective Organic Electrochemical Transistors: Recent Progress and Challenges

Recent advances in solid-contact ion-selective electrodes: functional materials, transduction mechanisms, and development trends.

Performance Optimization of Ionic Polymer Sensors through Characteristic Regulation of Chemically Prepared Interfacial Electrodes

Potentiometric/time resolved chronopotentiometric sensing for an all-solid-state ion-selective electrode based on MXene/MWCNTs as solid contact

Calibration-free and Ready-to-use Wearable Electroanalytical Reporting System (r-WEAR) for Long-term Remote Monitoring of Electrolytes Markers

Epidermal Sensor for Potentiometric Analysis of Metabolite and Electrolyte

MXene-Coated Ion-Selective Electrode Sensors for Highly Stable and Selective Lithium Dynamics Monitoring

Development of Machine Learning Models for Ion-Selective Electrode Cation Sensor Design