Abstract:Horizontal wells have significant advantages in coal bed methane exploration and development blocks. However, its application in new exploration and development blocks could be challenging. Limited geological data, uncertain geological conditions, and the emergence of micro-faults in pre-drilled target coal seams make it hard to accurately control the well trajectory. The well trajectory prior to drilling needs to be optimized to ensure that the drilling trajectory is within the target coal seam and to prevent any reduction in drilling ratio (defined here as the percentage of the drilling trajectory in the entire horizontal section of the well located in the target coal seam) caused by faults. In this study, the well trajectory optimization is achieved by implementing the following process to drill pilot hole, acquire 2D resonance, and azimuthal gamma logging while drilling. The pilot hole drilling can obtain the characteristic parameters of the target coal seam and the top and bottom rock layers in advance, which can provide judgment values for the landing site design and real-time monitoring of whether the wellbore trajectory extends along the target coal seam; 2D resonance exploration can obtain the construction of set orientation before drilling and the development of small faults and formation fluctuations in the horizontal section, which can optimize the well trajectory in advance; the azimuth gamma logging while drilling technology can monitor the layers drilled by the current drill bit in real time, and can provide timely and accurate well trajectory adjustment methods.The horizontal well-Q in the Block-W of the Qinshui Basin was taken as a case study and underwent technical mechanism research and applicability analysis. The implementation of this new innovative process resulted in a successful drilling of a 711 m horizontal section, with a target coal seam drilling rate of 80%. Compared to previous L-type wells, the drilling rate increased by about 20%, and the drilling cycle shortened by 25%. The technical experience gained from this successful case provides valuable insight for low-cost exploration and development of new coalbed methane blocks.

Research on Integrated Layer Determination and Fault Crossing Technology of Multi-branch Horizontal Wells for Surface Area Management

Field Research and Application of Tracking Adjustment Technology While Drilling for a Horizontal Well in Block A

Research on trajectory control technology for L-shaped horizontal exploration wells in coalbed methane

Key Technology of Directional Drilling for Water Prevention and Control of Bottom plate Limestone in Zhangji Coal Mine

The Two Zones of Floor Failure and its Control via a 'Dual Key Layer' Approach

Mechanism of and Prevention Technology for Water Inrush from Coal Seam Floor under Complex Structural Conditions—A Case Study of the Chensilou Mine

Numerical simulation study on the effect of upper aquifer on coalbed methane development

Rock Strata Failure Behavior of Deep Ordovician Limestone Aquifer and Multi-level Control Technology of Water Inrush Based on Microseismic Monitoring and Numerical Methods

Precise application of grouting technology in underground coal mining: water inrush risk of floor elimination

Prevention and Control of Water Inrushes from Subseam Karstic Ordovician Limestone During Coal Mining Above Ultra-thin Aquitards

Groundwater runoff pattern and keyhole grouting method in deep mines

Study on Optimization of Waterproof Coal Pillar in High Angle Normal Fault Floor

Study on Zonal Cooperative Control Technology of Surrounding Rock of Super Large Section Soft Rock Chamber Group Connected by Deep Vertical Shaft

Integration research of seismic data and logging for hydraulic fracturing in ultra-deep carbonate reservoirs with faults

Study of water-conducting fractured zone development law and assessment method in longwall mining of shallow coal seam

Physical simulation study on grouting water plugging of flexible isolation layer in coal seam mining

Research and Application of the Horizontal Multistage Fracture Technology

Mechanism and Control of Water–Rock Coupling-Induced Disaster when Mining below the Unconsolidated Confined Aquifer

Advances in Key Technologies for Accurate Identification, Monitoring and Early Warning of Disaster Risks in Service Wellbores

Research on gas drainage technology and equipment of high-level directional drilling in coal mine

Research and Practice on Key Technology of Drilling Ultra-deep Horizontal Wells at Southeast Block in Gulf of Mexico