Abstract:Aiming at the problems of safety production cost caused by the increase of mining face width and pressure mining in Xizhuo Coal Mine in Chenghe Mining area, a mechanical model of floor plastic slip failure is established based on the theory of plastic slip line, and the difference between it and the traditional floor failure model is analyzed. The damaged contour line of the support stress and lateral support stress on the bottom plate through the advancing direction of the working face is the intersection line of a straight line and an arc line. The failure of the floor caused by lateral supporting stress is the failure of the floor again on the basis of the failure of the floor in the advancing direction of the working face, and there is a superimposed failure area. The analysis of the failure form of the stope floor by this mechanical model is closer to the engineering practice. By using "ultrasonic detection method + stress monitoring inverse analysis method," the measured data such as disturbance failure depth and distribution law of large mining width working face were obtained. The test method used in this paper is relatively rare in the monitoring of the depth of floor disturbance failure at home and abroad. Considering that the traditional pressure water test method has disadvantages such as easy collapse hole, long period, and large error in monitoring the failure rule of deep floor rock mass, the embedded stress monitoring and reverse analysis method and ultrasonic detection method are used to successfully collect and real‐time monitor the data of rock floor before, during and after mining in the lower part of wide mining face of Xizhuo Coal Mine for the first time, and several effective data are obtained, which solves the three‐part "spatial‐time" all‐round floor disturbance and failure law field measurement which cannot be realized by traditional testing technology. By comparing the results of theoretical analysis, field measurement, and numerical simulation, the law and depth of floor disturbance failure of a 240‐m wide mining face in the Chenghe mining area are obtained for the first time, which provides scientific guidance for floor water disaster induced by coal seam mining under similar conditions in the future and has an important reference role for the prevention and control of Ordovician ash water disaster in coal mining. It provides important technical parameters for the safe setting of the effective water barrier layer and the selection and timing of the grouting layer of the floor, which can bring considerable economic and social benefits. The research results have important popularization value.

The Two Zones of Floor Failure and its Control via a 'Dual Key Layer' Approach

Failure Mechanism of Grouted Floor with Confined Aquifer Based on Mining-Induced Data

Numerical Analysis of the Water-blocking Performance of a Floor with a Composite Structure under Fluid–solid Coupling

Mechanism of and Prevention Technology for Water Inrush from Coal Seam Floor under Complex Structural Conditions—A Case Study of the Chensilou Mine

Rock Strata Failure Behavior of Deep Ordovician Limestone Aquifer and Multi-level Control Technology of Water Inrush Based on Microseismic Monitoring and Numerical Methods

Precise application of grouting technology in underground coal mining: water inrush risk of floor elimination

Floor Failure Evolution Mechanism for a Fully Mechanized Longwall Mining Face above a Confined Aquifer

Study on Optimization of Waterproof Coal Pillar in High Angle Normal Fault Floor

Analysis of Coal Floor Fault Activation Inducing Water Inrush Using Microseismic Monitoring—A Case Study in Zhaogu No. 1 Coal Mine of Henan Province, China

Experimental Study on Floor Damage and Slurry Material Ratio Optimization in Deep and High Confined Water Mining

Water Inrush Modes Through a Thick Aquifuge Floor in a Deep Coal Mine and Appropriate Control Technology: A Case Study from Hebei, China

Detection and Theoretical Numerical Simulation of the Failure Depth of the Bottom Plate in Belt Pressure Mining

Theoretical and numerical investigations of the floor failure characteristics affected by coal mining near complex fault structures

A New Method for Evaluating Floor Spatial Failure Characteristics and Water Inrush Risk Based on Microseismic Monitoring

Porosity zoning characteristics of fault floor under fluid-solid coupling

Prevention and Control of Water Inrushes from Subseam Karstic Ordovician Limestone During Coal Mining Above Ultra-thin Aquitards

Management and Utilization of High-Pressure Floor-Confined Water in Deep Coal Mines

Floor Failure Characteristics of Thick Coal Seam Mining Above Confined Aquifer

Influence Analysis of Mining’s Effect on Failure Characteristics of a Coal Seam Floor with Faults: A Numerical Simulation Case Study in the Zhaolou Coal Mine

A reinforcement method of floor grouting in high-water pressure working face of coal mines: a case study in Luxi coal mine, North China

A two-dimensional model test system for floor failure during automatic roadway formation mining without pillars above confined water