Abstract:Abstract A radiofrequency (RF) ion source with a megawatt power extraction, thunder I, has been developed for the neutral beam injector (NBI) on HL-2A tokamak. A full solid-state RF generator with output power of 80 kW and frequency of 2 MHz was built by an RF combiner using 8 modules of solid-state RF generator with power of P RF = 10 kW. The line electric efficiency of whole RF generator reaches 92% and its voltage standing wave ratio (VSWR) is 1.01, thus no water-cooling system is supplied. A quartz vessel with the inner diameter of 250 mm is directly adopted for resisting atmospheric pressure, which can dramatically simplify source structure. Nowadays, the extracted beam parameters of RF hydrogen ion source are 32 kV/20 A/0.1 s on a test bed, while the design parameters are 50 kV/20 A/3 s. The beam density profile measured by the infrared imaging technique at 1.3 m downstream from the grounded grid obeys a Gaussian distribution, and the corresponding half width of 1/ e power decay at the matched condition is about 80 mm. Plasma homogeneity is over 90% at low RF power. The beam divergence angle meets the requirement of NBI system on HL-2A tokamak. The extractable current density increases almost linearly with the RF power. It reaches 2400 A m −2 at P RF = 32 kW. The ion density in front of plasma grid is about 1 × 10 18 m −3 , corresponding to an ionized fraction of about 1% at the gas pressure of 0.5 Pa. Single hydrogen ion fraction reaches 79% at the beam current of 12.4 A. Some improvements have been considered for optimizing ion source performance on next experimental campaign. One smaller auxiliary RF discharge chamber equipped with a gas feed path, driven by 13.56 MHz/3.5 kW generator, is connected to main discharge chamber driven by 2 MHz/40 kW generator. By this dual-driven configuration, the innovative RF plasma source with high-pressure density gradient solves the initial ignition problem of powerful RF ion source even if the gas pressure below 0.1 Pa. In addition, the RF negative hydrogen ion source of 200 kV/20 A/3600 s is also developed at SWIP for the China fusion engineering test reactor.

Simulations for the cesium dynamics of the RF-driven prototype ion source for CRAFT N-NBI

First Prototype of a Cesium Oven Design for Negative-Ion-Source-Based Neutral Beam Injector at ASIPP

Influence of cusp magnetic field configuration on plasma parameters of radio frequency driven negative ion source for CRAFT NNBI

The spatio-temporal evolution of laser-induced initial plasma in RF ICP source for CFETR NBI

Suppression of stray electrons in the negative ion accelerator of CRAFT NNBI test facility

Design and Testing of Cesium Atomic Concentration Detection System Based on TDLAS

Study on stray electrons ejecting from a long-pulse negative ion source for fusion

Structure design and analysis of RF ion source for negative ion source test facility

Simulation of longitudinal dynamics of laser-cooled and RF-bunched C$^{3+}$ ion beams at heavy ion storage ring CSRe

Research and development progress of radio frequency ion source for neutral beam injector at ASIPP

Design of infrared radiation diagnostic calorimeter for the prototype radio frequency driven negative ion source for neutral beam injection

Final design and manufacturing of the neutralizer for the negative ion-based neutral beam injector test facility of CRAFT

Research of Cesium Adsorption on Mo and Ni Based on Temperature-Controlled Quartz Microbalance

Physics and engineering design of 400 keV H- accelerator for negative ion based neutral beam injection system in China

The engineering design of half-size RF negative ion source for CRAFT-NNBI

Simulation of beam-induced plasma in gas-filled rf cavities

Engineering design and manufacturing of a radio frequency plasma driver without Faraday shield for NBI application

Development of megawatt radiofrequency ion source for the neutral beam injector on HL-2A tokamak

Design of acceleration grid power supply for CFETR negative-ion-based neutral beam injection prototype

Stable Acceleration of a LHe-Free Nb3Sn demo SRF e-linac Based on Conduction Cooling

Plasma discharge experiments of a Faraday shieldless driver for high-power and long-pulse radio frequency ion source for NBI application