Abstract:Wet gas metering with differential pressure (DP) devices (e.g. the orifice plate, the Venturi and the V-Cone) has gained increasing interest in the oil and gas industry. Many investigations have been performed and several models have been proposed. Among the DP devices, the V-Cone flow meter has received increasing attention owing to its remarkable performance characteristics, including high accuracy, excellent repeatability, wide turndowns, shorter straight length and stable signals. In this work, we developed a new method for predicting the gas flow rate in low pressure wet gas flow using a V-Cone flow meter with the diameter ratio of 0.55. The experimental fluid was air and tap water. The test pressure ranged from 0.10 to 0.48 MPa, and the gas and liquid mass flow rates ranged from 100 to 500 N m3 h−1 and from 0.030 to 0.358 m3 h−1, respectively. Thus, the Lockhart–Martinelli parameter, XLM, was up to 0.158 and the gas volume fraction ranged from 98.94% to 100%. A dimensionless parameter, K, was proposed in this work and defined as the two-phase flow coefficient of the flow meter. The results indicated that the K linearly increased with the Lockhart–Martinelli parameter. In addition, the K increased with the gas densiometric Froude number and decreased with the operating pressure when other parameters were kept constant. On the basis of the two-phase flow coefficient, a new wet gas model was developed and compared with seven popular wet gas models. It was found that with the V-Cone flow meter and under the present experimental conditions the new model produced a more accurate prediction of the wet gas than other models. The research approach to obtaining the model can also be used in the studies on other DP devices and thus will benefit the design of wet gas meters.

Wet gas flow metering by combining a vortex flowmeter with disturbance wave frequency

Wet gas metering using a vortex cross-correlation meter based on fluctuating pressure measurement

Online Measurement of Gas and Liquid Flow Rates in Wet Gas Using Vortex Flowmeter Coupled With Conductance Ring Sensor

Measurement of the Flow Rate and Volume Void Fraction of Gas-Liquid Bubble Flow Using A Vortex Flow Meter

Measuring the Uncertainty of Gas-liquid Mixed Flows Using Vortex Flowmeter

A new overreading model for wet gas vortex metering based on vorticity transport mechanism

Study on measuring conducting liquid flow with gas by electromagnetic vortex flowmeter

Measurement method of wet gas two-phase flow rate based on the main frequency and the modulus of vector acceleration of swirl flowmeter

Online Measurement of Wet Gas Mass Flowrate Based on Averaging Pitot Tube-Vortex Integrated Sensor

Design of ultrasonic flowmeter for wet gas measurement

On Measurement Property of Vortex Flowmeter in Bubbly Two-Phase Flows

Impact Analysis of Vortex Flowmeter Measured with Duct-Wall Differential Pressure Method

Development of an Anti-Interference Swirl Meter Based on Numerical Simulation of Hydrodynamic Vibration

A New Method for Wet Gas Flow Measurement with Horizontal Venturi Meter Based on Numerical Simulation

Gas and Liquid Flow Rate Measurement in Wet Gas Based on Differential Pressure Signals

A New Model for the V-Cone Meter in Low Pressure Wet Gas Metering

A study of mass flow rate measurement based on the vortex shedding principle

Anti-strong pipeline vibration method combining frequency variance and amplitude feature for vortex flowmeter

Wet gas measurements of long-throat Venturi Tube based on forced annular flow

A New Model for Wet Gas Flow Measurement with V-Cone Meter

Oil-Gas-Water Three-Phase Flow Measurement Based on the Theory of Partial Separation