Abstract:Wet gas metering with differential pressure (DP) devices (e.g. the orifice plate, the Venturi and the V-Cone) has gained increasing interest in the oil and gas industry. Many investigations have been performed and several models have been proposed. Among the DP devices, the V-Cone flow meter has received increasing attention owing to its remarkable performance characteristics, including high accuracy, excellent repeatability, wide turndowns, shorter straight length and stable signals. In this work, we developed a new method for predicting the gas flow rate in low pressure wet gas flow using a V-Cone flow meter with the diameter ratio of 0.55. The experimental fluid was air and tap water. The test pressure ranged from 0.10 to 0.48 MPa, and the gas and liquid mass flow rates ranged from 100 to 500 N m3 h−1 and from 0.030 to 0.358 m3 h−1, respectively. Thus, the Lockhart–Martinelli parameter, XLM, was up to 0.158 and the gas volume fraction ranged from 98.94% to 100%. A dimensionless parameter, K, was proposed in this work and defined as the two-phase flow coefficient of the flow meter. The results indicated that the K linearly increased with the Lockhart–Martinelli parameter. In addition, the K increased with the gas densiometric Froude number and decreased with the operating pressure when other parameters were kept constant. On the basis of the two-phase flow coefficient, a new wet gas model was developed and compared with seven popular wet gas models. It was found that with the V-Cone flow meter and under the present experimental conditions the new model produced a more accurate prediction of the wet gas than other models. The research approach to obtaining the model can also be used in the studies on other DP devices and thus will benefit the design of wet gas meters.

A new overreading model for wet gas vortex metering based on vorticity transport mechanism

Wet gas metering using a vortex cross-correlation meter based on fluctuating pressure measurement

Numerical investigation of wet gas flow in Venturi meter

Study on the wet gas metering technology based on slotted orifice and vortex precession flow-meter

Wet gas flow metering by combining a vortex flowmeter with disturbance wave frequency

Wet gas flow modeling for a vertically mounted Venturi meter

Experimental and numerical study on wet steam flow metering overreading characteristics in venturi tube

Measurement of the Flow Rate and Volume Void Fraction of Gas-Liquid Bubble Flow Using A Vortex Flow Meter

A New Model for the V-Cone Meter in Low Pressure Wet Gas Metering

Measuring the Uncertainty of Gas-liquid Mixed Flows Using Vortex Flowmeter

Venturi Wet Gas Flow Modeling Based on Homogeneous and Separated Flow Theory

Wet gas meter based on the vortex precession frequency and differential pressure combination of swirlmeter

A New Correlation of Wet Gas Flow for Low Pressure with a Vertically Mounted Venturi Meter

Numerical Study on Annular-Mist Flow in V-Cone Meter for Wet Gas Metering

Modeling of wet gas flow in Vertically mounted Venturi meter

Evaluation of uncertainty in a vortex flowmeter measurement

Online Measurement of Gas and Liquid Flow Rates in Wet Gas Using Vortex Flowmeter Coupled With Conductance Ring Sensor

A study of mass flow rate measurement based on the vortex shedding principle

On fluctuation of the dynamic differential pressure signal of Venturi meter for wet gas metering

Measurement of vortex flowmeter using tri-axis acceleration probe based on multi-parameter adjustable mist flow loop

Wet Gas Overreading Characteristics of a Long-Throat Venturi at High Pressure Based on CFD