Abstract:TiO2 nanocrystallines with a size of 3–7 nm have been synthesized by the sol–gel method with excessive water at a low temperature of about 50°C. The effects of amount of water and pH on the formation of sols and powders containing TiO2 nanocrystallines were investigated by X‐ray powder diffraction (XRD), transmission electron microscopy, and high‐resolution transmission electron microscopy. The results showed that a pure anatase phase was formed at pH 1, in contrast to the formation of particles with a mixture of anatase and brookite phases at pH 2–7. Moreover, at pH 1, the intensity of the XRD peaks and the crystal size increased with increasing water content when the water ratio increased from 40 to 100. Whereas the crystal intensity remained invariant, the crystal size still increased when the water ratio increased from 100 to 400. The photocatalytic activity was also investigated. It was shown that when the water ratio was below 100, the photocatalytic activity increased with increasing water content. Further increase of the water content decreased the photocatalytic activity. The photocatalytic activity decreased with increasing pH. All samples with pH=1 showed better photocatalytic activity than Degussa P25. Mechanisms for the formation of the TiO2 nanocrystalline particles at such a low temperature were also discussed.

The influence of pH value on the synthesis of ytterbium silicate nano-powders by cocurrent coprecipitation method

The Effect of pH value on the nano-particle size of bi substituted yttrium iron garnet

Structural evolution and synthesis mechanism of ytterbium disilicate powders prepared by cocurrent chemical coprecipitation method

Controllable Synthesis of SiO2 Nanoparticles: Effects of Ammonia and Tetraethyl Orthosilicate Concentration

Effect of pH value on synthesis process and luminescence behavior of p-hydroxybenzoic acid-terbium complex in gel

Influence of Ph on the Morphology of Yttrium Oxide Hydroxide Nitrate Nanocrystal

Synthesis of Tin Oxide Nanoparticles by Precipitation Process: Effects of pH and Temperature on the Particle Size and Morphology

pH control on preparation of nano-TiO_2 by gel-sol process

Influence of Surfactants on Co-Precipitation Synthesis of Bi–YIG Particles

Synthesis of non‐agglomerating submicron/nano Yb 2 Si 2 O 7 powders by carbon‐coated coprecipitation method

Effects of Water Amount and Ph on the Crystal Behavior of a TiO2 Nanocrystalline Derived from a Sol–Gel Process at a Low Temperature

The Preparation SiC/YAG Composite Powders by Co-Precipitation Method

Influence of Ph Value on Properties of Nanocrystalline BaTiO3 Powder

Study on Preparation of Yttrium Oxide with Large Particle Sizes and Spherical Shapes by Precipitation with Ammonium Bicarbonate

Synthesis of Ytterbium-Doped Yttrium Aluminum Garnet Laser Ceramic Nano-Powders by Carbonate Altogether Precipitation Method

Effects of Preparing Conditions on the Synthesis of Y2SiO5 Nanoparticles by Low-Temperature Molten Salt Method

Synthesis of Y2O3 nanopowders and transparent Y2O3 ceramics by carbonate-precipitation process

Synthesis of Nanosized NaY Molecular Sieve under Dynamic Hydrothermal Crystallization

Microstructure and synthesis mechanism of ScYSZ powders prepared by chemical co-precipitation with different dynamic microenvironment

Effects of Different Sintering Additives on the Synthesis of Γ-Y2si2o7 Powders

Synthesis of nanoscaled yttrium aluminum garnet powder by the co-precipitation method