Abstract:Al-Si welding wire is commonly used in the aluminum alloy welding due to the excellent heat crack-resistance and corrosion-resistance, but the presence of large-sized pores hinders its widespread application in the field of laser welding. This study focuses on the cause of pores formation in the laser welding using Al-Si wires with different Si contents and investigates the dynamic behavior of laser keyhole by a high-speed camera-based molten pool monitoring system. The results showed that with the increase of wire Si content from 5% to 12% (wt.%), the keyhole stability decreased and the weld porosity increased. According to the thermodynamic calculations, the increased Si content enhanced the Reynolds number of molten pool, resulting in increased turbulence tendency. It caused the molten pool being more susceptible to external disturbances, which decreased the stability of keyhole. Furthermore, the reduced dynamic viscosity of molten pool increased both the depth-to-width ratio of keyhole and its opening and closing frequency. These combined effects ultimately contributed to the increased susceptibility to pores formation. Based on the above results, a circular oscillating laser was introduced to guide the regular flow of molten pool. The beam oscillation improved the resistance to fluctuations of molten pool and reduced the depth-to-width ratio of keyhole. Besides, the high-frequency rotating keyhole could capture and re-melt the formed pores. An optimal laser oscillating welding was determined using response surface methodology to control the porosity within the acceptable range.

Influence of surface pretreatment on porosity and microstructure of laser welding in AlSi10Mg alloys sheets fabricated by laser powder bed fusion

Effect of heat treatments on microstructure and mechanical behavior of laser welded LPBF AlSi10Mg alloys

The Influence of Post-Treatment on Micropore Evolution and Mechanical Performance in AlSi10Mg Alloy Manufactured by Laser Powder Bed Fusion

Porosity Formation and Its Effect on the Properties of Hybrid Laser Welded Al Alloy Joints

MECHANISMS OF THE POROSITY FORMATION DURING THE FIBER LASER LAP WELDING OF ALUMINIUM ALLOY

Microstructure and mechanical properties of laser welded hot-press-formed steel with varying thicknesses of Al-Si coatings cleaned by nanosecond pulsed laser

Mechanical behavior and microstructure evolution of Al-Cu-Mg alloy produced by laser powder bed fusion: Effect of heat treatment

Mechanisms of the Porosity Formation During the Fiber Laser Lap Welding of Al 5754 Sheets

Effect of Pulsed Laser Pretreatment on the Performance of Butt Joints in Laser Welding-Brazing of Titanium/Aluminum Dissimilar Alloys

Experimental Investigation and Numerical Study on the Elimination of Porosity in Aluminum Alloy Laser Welding and Laser–GMA Welding

Effect of Surface Treatments on the Laser Welding Performance of Dissimilar Materials

Effect of ambient pressure on laser welding of AlSi10Mg fabricated by selected laser melting

Influence of Laser Process on the Porosity-Related Defects, Microstructure and Mechanical Properties for Selective Laser Melted AlSi10Mg Alloy

Porosity Sensitivity of A356 Al Alloy During Fiber Laser Welding

Evolution of multi pores in Ti6Al4V/AlSi10Mg alloy during laser post-processing

Study on the influence of Al-Si welding wire on porosity sensitivity in laser welding and process optimization

Oxygen content and morphology of laser cleaned 5083 aluminum alloy and its influences on weld porosity

Porosity inhibition of aluminum alloy by power-modulated laser welding and mechanism analysis

Effect of the Welding Direction on the Microstructural Characterization in Fiber Laser-Gmaw Hybrid Welding of 5083 Aluminum Alloy

Microstructure and Mechanical Properties of Laser-Mig Hybrid Welding of 1420 AlLi Alloy

The Influence of Heat and Cryogenic Treatment on Microstructure Evolution and Mechanical Properties of Laser-Welded AZ31B