Abstract:Rocks in cold regions tend to experience exacerbated degradation under the combined effects of environmental and anthropogenic factors, which may arise from, for example, temperature fluctuation, mechanical excavation, and blasting. Activities related to rock support or open-pit slope optimization in cold regions require a complete understanding of the failure mechanisms of rock under the complex conditions. This paper quantitatively documents the impact of combined cyclic mechanical load and freeze-thaw cycles (i.e., the effect of stress “history”) on the microstructural evolution and mechanical degradation of three porous sandstones with distinct porosity values (from 3.9 to 14.1%). The three sandstone samples were collected from different geological regions in China. The microstructural evolution of the tested samples was quantitatively analyzed using the low-field Nuclear Magnetic Resonance (NMR) technique. To investigate sample degradation arising from the impact of the stress “history”, the cyclic-loaded and freeze-thaw cycled samples were eventually compressed to failure, during which an acoustic emission system was used to monitor microseismic activities. The results of the study show that the porosity of all tested sandstone samples was increased after cyclic load, with a much more rapid and further increase in porosity observed for samples being subsequently treated under the freeze-thaw cycles. More interestingly, the Chuxiong sandstone with relatively small porosity values were much more sensitive to the impact of cyclic load compared with the Linyi sandstone, exhibiting a somewhat larger increase rate in porosity. However, the Linyi sandstone with larger initial porosity values exhibited a relatively large increase rate in porosity under the multiple freeze-thaw treatments. The multiple freeze-thaw treatments mainly resulted in the development of relatively large pores. The results of the uniaxial compression tests show that the strength reduction of the samples being solely treated by freeze-thaw cycles was within the range of 5–10%, whereas it was within the range of 20–40% for those samples subjected to the combined cyclic load and freeze-thaw cycles.

Effect of wet-dry cycling on the pore characteristics of red sandstone after heat treatment

Influence of high-temperature thermal cycles on the pore structure of red sandstone

Effects of high-temperature thermal treatment on the porosity of red sandstone: an NMR analysis

Effect of Dry–Wet Cycling on the Degradation Characteristics and Mechanisms of Red Sandstone

Effect of Thermal Cycling and Hydro‐thermal Cycling on Physical and Mechanical Properties of Sandstone

Effect of Water Saturation on Dynamic Behavior of Sandstone after Wetting-Drying Cycles

Influence of Cyclic Wetting and Drying on Physical and Dynamic Compressive Properties of Sandstone

Influence of Wetting-Drying Cycles on the Pore Structure and Mechanical Properties of Mudstone from Simian Mountain

Experimental Investigations on the Effects of Ambient Freeze-Thaw Cycling on Dynamic Properties and Rock Pore Structure Deterioration of Sandstone

Experimental Study on the Deterioration Mechanism of Sandstone under the Condition of Wet-Dry Cycles

Effect of Wet-Dry Cycles on the Mechanical Performances and Microstructure of Pisha Sandstone

A Stratified NMR-Based Investigation of Spatial Evolution of Pore Structure in Sandstone After Cyclic Heating and Local Water Cooling

Coupled effects of chemical environments and freeze–thaw cycles on damage characteristics of red sandstone

Influence of drying-wetting cycles on microstructure degradation of argillaceous sandstone using low field nuclear magnetic resonance

Experimental Study on Dynamic Compression Characteristics of Red Sandstone under Wetting-Drying Cycles

Influence of Drying-Wetting Cycles on Dynamic Tensile Properties of Red-Sandstone Using the Brazilian Test

Multi-scale Experimental Investigations on the Deterioration Mechanism of Sandstone Under Wetting–Drying Cycles

Study on the effect of high-temperature dry–wet cycles on argillaceous sandstone

The Mesoscopic Damage Mechanism of Jointed Sandstone Subjected to the Action of Dry–Wet Alternating Cycles

Combined Effects of Cyclic Load and Temperature Fluctuation on the Mechanical Behavior of Porous Sandstones

Research on the Pore Evolution of Sandstone in Cold Regions under Freeze-Thaw Weathering Cycles Based on NMR