Abstract:The sandstone is in a state of dry–wet cycle under the repeated action of rainfall, and its mechanical properties are deteriorated to varying degrees, which causes cracks in the sandstone. Therefore, it is of great significance to study the mechanical properties and fracture propagation of sandstone under the action of dry–wet cycles. Currently, there are limited studies using numerical simulation methods to study the fracture extension of rocks under various dry and wet cycling conditions.Therefore, in this paper, the effects of different amounts of dry and wet cycling on the mechanical properties and fracture behavior of sandstone are investigated through uniaxial compression tests and numerical simulations of fracture extension. The findings indicate that the deformation stage of sandstone remains unchanged by the dry–wet cycle. The uniaxial compressive potency and coefficient of restitution gradually diminish as the quantity of cycles rises, while the Poisson's ratio exhibits the opposite trend, and the impact on the mechanical performance of sandstone wanes with cycle increments, and the correlation coefficient surpasses 0.93, signifying a substantial influence of the dry–wet cycle on sandstone's mechanical performances. The discrepancy between the numerical simulation and experimental results is minimal, with a maximum error of only 3.1%, demonstrating the congruence of the simulation and experimental outcomes.The mesoscopic examination of the simulations indicates that the quantity of fractures in the sandstone specimens rises with the escalation of dry–wet cycles, and the steps of analysis linked to crack inception and fracture propagation are accelerated, and the analysis steps from fracture initiation to penetration are also reduced.

Experimental Study on Dynamic Compression Characteristics of Red Sandstone under Wetting-Drying Cycles

Influence of Drying-Wetting Cycles on Dynamic Tensile Properties of Red-Sandstone Using the Brazilian Test

Dynamic Tensile Failure Characteristics and Energy Dissipation of Red Sandstone under Dry–Wet Cycles

Deterioration of dynamic fracture characteristics, tensile strength and elastic modulus of tight sandstone under dry-wet cycles

Investigating the impact of the quantity of wet and dry cycles on the mechanical characteristics and fracture variations of sandstones

Fracture behavior and damage mechanisms of sandstone subjected to wetting-drying cycles

Experimental Study of Macro- and Micro-Scopic Damage in Red Sandstone under Dry and Wet Cycling

Multi-scale Experimental Investigations on the Deterioration Mechanism of Sandstone Under Wetting–Drying Cycles

Degradation of Strength and Stiffness of Sandstones Caused by Wetting-Drying Cycles: The Role of Mineral Composition

Experimental Study on the Deterioration Mechanism of Sandstone under the Condition of Wet-Dry Cycles

Assessments of Tensile Characteristics and Degradation Mechanism of Sandstone Subjected to Wetting–Drying Cyclic Treatment

A Study of Dynamic Compressive Strength and Microscopic Mechanism on Water-Bearing Rock

Effect of Dry–Wet Cycling on the Degradation Characteristics and Mechanisms of Red Sandstone

Dynamic Mechanical Response and Dissipated Energy Analysis of Sandstone under Freeze-Thaw Cycles

Effect of impact loading and acidic drying-wetting cycles on fragmentation and energy dissipation characteristics of sandstone

Damage mechanism evolution of red sandstone under drying–wetting cycles: experiment and discrete element modeling

Effects of dry-wet cycles on the mechanical properties of sandstone with unloading-induced damage

Study on Long-Term Dynamic Mechanical Properties and Degradation Law of Sandstone under Freeze-Thaw Cycle

Effect of wet-dry cycling on the pore characteristics of red sandstone after heat treatment

Experimental Study on Dynamic Mechanical Characteristics and Energy Evolution of Sandstone under Cyclic Impact Loading

Study on the change of physical properties of sandstone under action of acidic drying-wetting cycles and discrete element simulation