Abstract:AbstractIn geothermal energy development, high-temperature rock mass will go through the process of water cooling. It is of great significance to study the physical and mechanical characteristics and microstructure of high-temperature rock after water cooling for the long-term stability analysis of underground engineering. Based on this, the surface characteristics, mass, and volume variation of sandstone cooled by water at high temperatures (100, 200, 400, 600, 800, and 1000 °C) were investigated. Using the Rock Top multifield coupling tester, a series of axial compressions and longitudinal wave velocity tests of the sandstone after a high temperature-water cooling treatment are performed. The microstructure characteristic obtained by X-ray diffraction and scanning electron microscope was studied, and the effect of high temperature-water cooling behavior on the mechanical properties of sandstone was investigated. The results show that: (1) The mass loss rate, volume expansion rate and peak strain of sandstone increase with increasing temperature, while peak strength decreases gradually. When the temperature exceeds 400 °C, the physical and mechanical parameters of sandstone change markedly. (2) When the temperature is less than 400 °C, corresponds to the compressive and line-elastic phases, the stable crack propagation phase, the rapid crack propagation phase and the destructive phase during the failure process of sandstone, the wave velocity of sandstone are steadily increasing, oscillating, and sharply decreasing, respectively. While the temperature is below 1000 °C, the wave velocity of sandstone is oscillation increases, slows down and drops sharply, respectively. (3) When the temperature is below 400 °C, the mineral content of sandstone varies less. While the temperature exceeds 400 °C, there is an overall increasing trend in the sodium feldspar content of sandstone. (4) The increase in temperature promotes the development of pore fractures within the sandstone, especially at higher temperature states where microcracks expand along the intergranular to form microcrack networks, leading to an increase in the scale and number of defects such as fractures within the sandstone.

A Stratified NMR-Based Investigation of Spatial Evolution of Pore Structure in Sandstone After Cyclic Heating and Local Water Cooling

NMR Pore Structure and Dynamic Characteristics of Sandstone Caused by Ambient Freeze-Thaw Action

Research on the Pore Evolution of Sandstone in Cold Regions under Freeze-Thaw Weathering Cycles Based on NMR

The Evolution of Sandstone Microstructure and Mechanical Properties with Thermal Damage

Evolution of Micro-Damage and Degradation of Macro-Mechanical Properties of Sandstone Due to Thermal Effects

Experimental Study of the Pore Structure Deterioration of Sandstones under Freeze-Thaw Cycles and Chemical Erosion

Experimental Study on Physical and Mechanical Characteristics and Microstructure of Sandstone after High Temperature-Water Cooling Treatment

Detecting freeze–thaw damage degradation of sandstone with initial damage using NMR technology

Experimental investigation on the damage and deterioration of sandstone subjected to cycling pore water pressure

An NMR-based Investigation of Pore Water Freezing Process in Sandstone

Low filed NMR and acoustic emission probability density study of freezing and thawing cycles damage for sandstone

Effects of high-temperature thermal treatment on the porosity of red sandstone: an NMR analysis

Effects of Rapid Cooling Treatment on Heated Sandstone: a Comparison Between Water and Liquid Nitrogen Cooling

Coupled effects of chemical environments and freeze–thaw cycles on damage characteristics of red sandstone

Influence of multiple porous structure evolution on physical–mechanical properties and damage mechanism of sandstone heated continuously/periodically with the identical heating time

Effect of wet-dry cycling on the pore characteristics of red sandstone after heat treatment

Damage characteristics of sandstone pore structure under freeze-thaw cycles

Combined Effects of Cyclic Load and Temperature Fluctuation on the Mechanical Behavior of Porous Sandstones

Evolution in sandstone pore structures with freeze-thaw cycling and interpretation of damage mechanisms in saturated porous rocks

Pore structure characterization of sandstone under different water invasion cycles using micro-CT

Experimental Investigations on the Effects of Ambient Freeze-Thaw Cycling on Dynamic Properties and Rock Pore Structure Deterioration of Sandstone