Abstract:The continuous miniaturization of modern electromechanical systems calls for a comprehensive understanding of the mechanical properties of metallic materials specific to micrometer and sub-micrometer scales. At these scales, the nature of dislocation-mediated plasticity changes radically: sub-micrometer metallic samples exhibit high yield strengths, however accompanied by detrimental intermittent strain fluctuations compromising forming processes and endangering structural stability. In this paper, we studied the effects of plate-like $\theta^\prime$-Al$_2$Cu precipitates on the strength, plastic fluctuations and deformation mechanisms of Al-Cu alloys from micro-pillar compression testing. The plate-like precipitates have diameters commensurate with the external size of the Al-Cu micro-pillars. Our results show that these plate-like precipitates can strengthen the materials and suppress plastic fluctuations efficiently at large sample sizes ($\geq 3 \mu m$). However, the breakdown of the mean-field pinning landscape at smaller scales weakens its taming effect on intermittency. Over an intermediate range of sample sizes allowing the precipitates to cross the entire pillar, an enhanced apparent strain hardening and a sharp decrease of jerkiness are observed, in association with the presence of {100}-slip traces along the coherent $\theta^\prime$-Al$_2$Cu precipitate/$\alpha$-Al matrix interface and precipitate shearing. These complex effects of plate-like precipitates on plasticity are analyzed, experimentally and theoretically, in view of the interferences between external and internal sizes, and the related modifications of the underlying plastic mechanisms.

On the shear strain associated with T 1 precipitation in Al-Cu-Li(-Mg-Ag) alloys

Investigation on formation mechanism of T1 precipitate in an Al-Cu-Li alloy

Atomic Structure of T1 Precipitates in Al–Li–Cu Alloys Revisited with HAADF-STEM Imaging and Small-Angle X-ray Scattering

Formation mechanism of precipitate T1 in AlCuLi alloys

Microstructure evolution and shearing behaviour of δꞌ/θꞌ/δꞌ precipitates in an aged Al-Cu-Li-Mg aluminium alloy

Characterization of precipitation in Al-Li alloy AA2195 by means of atom probe tomography and transmission electron microscopy

Heterogeneous nucleation of T1 precipitates in solid solution of Al-Cu-Li alloys from Ag-rich structures: An ab initio study

Coarsening mechanism of T1 precipitation and calculation of T1/Al interface properties in 2198 Al–Cu–Li alloys: Experimental and DFT studies

First-principles study of crystal structure and stability of T1 precipitates in Al-Li-Cu alloys

Quantitative contribution of T1 phase to the strength of Al-Cu-Li alloys

Regulation of precipitation behavior among T1, S', and θ' phases in Al–Cu–Li-(Mg–Ag) alloys by optimizing Ag/Mg ratios

Crystallographic relationships of T-/S-phase aggregates in an Al-Cu-Mg-Ag alloy

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Effect of pre-straining on structure and formation mechanism of precipitates in Al–Mg–Si–Cu alloy

Influence of microstructural and crystallographic inhomogeneity on tensile anisotropy in thick-section Al-Li-Cu-Mg plates

Insights into precipitation characteristics and strengthening mechanisms in a low Cu/Mg ratio Al-Cu-Mg-Ag alloy

Plate-like precipitate effects on plasticity of Al-Cu alloys at micrometer to submicrometer scales

Dynamic microstructural evolution of Al-Cu-Li alloys during hot deformation

The influence of Cu/Li ratio on precipitation in Al–Cu–Li–x alloys

Effect of second-phase precipitates on deformation microstructure in AA2024 (Al–Cu–Mg): dislocation substructures and stored energy

Enhanced matrix precipitation of T1 (Al2CuLi) phase in AA2055 Al–Li alloy during stress aging process