An investigation of the tensile deformation mechanism of a high-oxygen Ti2448 alloy fabricated by powder metallurgy by use of the in-situ EBSD method

Xia Li,Jinhui Wang,Shulong Ye,Yinghao Zhou,Peng Yu

DOI: https://doi.org/10.1016/j.msea.2021.141981

2021-11-01

Abstract:Ti2448 alloy fabricated by powder metallurgy using elemental powders of Ti, Nb, Zr and Sn exhibits good ductility but a high content of oxygen, and very limited work hardening in the tensile test. Its deformation mechanism is investigated by in-situ EBSD test conducted in an SEM equipped with a dynamic tensile stage. The results indicate that both dislocation slide and stress-induced phase transformation contribute to the plastic deformation of the alloy. Subsequent to yielding (after 3% of strain), β phase grains with preferential orientation 113β tend to be transformed into α" martensite phase, which significantly reduces the plastic deformation caused by the dislocation slide and therefore leads to low work hardening.

materials science, multidisciplinary,nanoscience & nanotechnology,metallurgy & metallurgical engineering