Abstract:The extruded AZ80+0.4% Ce magnesium alloy was twisted in the temperature range of 300 - 380 °C by using a Gleeble 3500 thermal simulation test machine with a torsion unit. The deformed cylindrical specimens were cooled at a cooling rate of 10 °C/s or 0.1 °C/s, respectively, and aged at 170 °C. The microstructure analysis results showed that the grain size decreased with increasing specimen radial position from center (SRPC), and that the strong initial basal texture of the extruded magnesium alloy was weakened. Both continuous and discontinuous dynamic recrystallization mechanisms were involved in contributing to the grain refinement for all specimens investigated. And a novel extension twinning induced dynamic recrystallization mechanism was proposed for specimen deformed at 300 °C. For the specimens deformed at 300 °C and 340 °C followed by a slow cooling rate (0.1 °C/s), precipitates of various shapes (β-Mg 17 Al 12 ), with the dominant precipitates being on the grains boundaries, appeared on the surface section. For specimen deformed at 380 °C, lamellar precipitates (LPS) in the interiors of the grains were predominant. After aging, the LPS still dominated for specimens twisted at 380 °C; however, the LPS gradually decreased with decreasing deformation temperatures from 380 °C to 300 °C. Dynamically precipitated β, especially those decorating the grain boundaries, changed the competition pictures for the LPS and precipitates of other shapes after aging. Interestingly, LPS dominated the areas for the center section of the specimens after aging regardless of deformation temperatures. Low temperature deformation with high SRPC followed by rapid cooling rate increased the micro hardness of the alloy after aging due to refined grain, reduced precipitates size, decreased lamellar spacing as well as strain hardening.

Effect of aging time on discontinuous precipitates, continuous precipitates and mechanical properties of AZ80A magnesium alloy

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Dependence of Tensile Properties and Fracture Behaviors on the Fractions of Continuous and Discontinuous Precipitates in Peak-Aged AZ80A Magnesium Alloy

Effect of Aging Temperature on Microstructure and Mechanical Properties of AZ81-4%Gd Magnesium Alloy

Microstructure and Mechanical Properties of Mg-Xy-1.5mm-0.4zr Alloys

Microstructure Characteristics and Effect of Aging Process on the Mechanical Properties of Squeeze-Cast AZ91 Alloy

Characterization of precipitates in aged Mg-4 wt%Zn alloy

Effects of Mg/Zn ratio and pre-aging on microstructure and mechanical properties of Al–Mg–Zn–Cu alloys

Effect of Over-Aging Degree on Microstructures, Precipitation Kinetics, and Mechanical Properties of an Ultra-High-Strength Al-Zn-Mg-Cu Alloy

The effects of deformation parameters and cooling rates on the aging behavior of AZ80+0.4%Ce

Study on Microstructural Evolution and GP Zone Strengthening Mechanism by Solution and Aging Treatment in Non-dendritic Mg-6Zn-5Al Magnesium Alloy

Effect of Y on Age Hardening Response and Mechanical Properties of Mg-xY–1.5LPC −0.4zr Alloys

Microstructure evolution and mechanical anisotropy of AZ80-Ag magnesium alloy: Effect of isothermal semi-closed die forging and subsequent aging

Nanocrystallization and precipitation behavior evolution of AZ80 magnesium alloy during multi-directional compression

Effects of Aging Process on the Damping Performance of ZK60 Magnesium Alloys Prepared by Large Strain Rolling

Microstructures and Mechanical Properties of Al-Zn-Mg-Cu Alloys under Multi-Directional Severe Strain and Aging

Effect of Aging Treatment on Microstructure and Damping Properties of Mg-Al-Ca-Mn-Zn Alloy

Aging hardening and precipitate behavior of a solution-treated Mg-6Zn-4Sn-1Mn (wt.%) wrought Mg alloy

A Preliminary Study on the Effects of Aging Temperature on the Microstructure and Mechanical Properties of As-Extruded Mg-12Gd-4Y-1Zn Magnesium Alloy

Precipitate Behavior, Mechanical Properties and Corrosion Behavior of an Al-Zn-Mg-Cu Alloy during Non-Isothermal Creep Aging with Axial Tension Stress

Influence of Zinc Chloride Exposure on Microstructure and Mechanical Behavior of Age-Hardened AZ91 Magnesium Alloy