Abstract:In order to implement numerical simulation of the thermal-mechanical behaviors in the nuclear fuel rods, a three-dimensional finite element model is established. The thermal-mechanical behaviors at the initial stage of burnup in both the pellet and the cladding are obtained. Comparison of the obtained numerical results with those from experiments validates the developed finite element model. The effects of the constraint conditions, several operation and structural parameters on the thermal-mechanical performances of the fuel rod are investigated. The research results indicate that: (1) with increasing the heat generation rates from 0.15 to 0.6 W/mm(3), the maximum temperature within the pellet increases by 99.3% and the maximum radial displacement at the outer surface of the pellet increases by 94.3%. And the maximum Mises stresses in the cladding all increase; while the maximum values of the first principal stresses within the pellet decrease as a whole; (2) with increasing the heat transfer coefficients between the cladding and the coolant, the internal temperatures reduce and the temperature gradient remains similar; when the heat transfer coefficient is lower than a critical value, the temperature change is sensitive to the heat transfer coefficient. The maximum temperature increases only 7.13% when h changes from 0.5 W/mm(2) K to 0.01 W/mm(2) K, while increases up to 54.7% when h decreases from 0.01 W/mm(2) K to 0.005 W/mm(2) K; (3) the initial gap sizes between the pellet and the cladding significantly affect the thermal-mechanical behaviors in the fuel rod; when the gap size varies from 0.03 mm to 0.1 mm, the highest temperature in the pellet increases by 19.7%, and the maximum first principal stress at the outer pellet surface decreases by 17.4%; it is critical to optimize the gap size in order to reduce the pellet-cladding mechanical interaction and avoid their contact at early stage. This study lays a foundation for the further research on the irradiation-induced mechanical behaviors in the fuel rods. (C) 2011 Elsevier Ltd. All rights reserved.

A modified small punch testing scheme to investigate the circumferential mechanical behavior of nuclear fuel cladding tubes

Small punch test for investigating circumferential creep in cladding tubes

Assessment of Toughness in Long Term Service Crmo Low Alloy Steel by Fracture Toughness and Small Punch Test

Improved approaches for small punch test to estimate the yield and ultimate tensile strength of metallic materials

A correlation-based approach for evaluating mechanical properties of nuclear fuel cladding tubes

Fracture toughness estimation of ductile materials using a modified energy method of the small punch test

Development of U-frame Bending System for Studying the Vibration Integrity of Spent Nuclear Fuel

Mandrel diameter effect on ring-pull testing of nuclear fuel cladding

A new small punch test method to predict tensile properties of steels: Representative stress–strain method

Investigation on the Tensile Properties of Inconel 625 Using Small Punch Test

Small Punch Testing for Assessing the Fracture Properties of the Reactor Vessel Steel with Different Thicknesses

Study on Influence Factors of Small Punch Test Based on Ductile Damage Numerical Analysis

Finite element analysis of equivalent fracture stress and strain in small punch specimen

Damage Analysis of In-Service Ethylene Cracking Furnace Tubes Using Small Punch Test

Mechanical Properties Study of Miniature Steel Specimens Based on the Small Punch Test and Simulation Methods

A Methodology to Assess Directional and Spatial Variations of Tensile and Fracture Properties in Fabricated Nuclear Components

In-situ study on the tensile property and fracture behavior of Cr coating for nuclear fuel cladding

Evaluating the tensile properties of high-strength stainless steels using small punch testing

SMALL PUNCH TEST FOR DETERMINING THE MATERIAL PROPERTIES OF Cr-Mo STEEL AFTER LONG-TERM SERVE AT HIGH TEMPERATURE

Three-dimensional FE analysis of the thermal-mechanical behaviors in the nuclear fuel rods

Mechanics of the small punch test: a review and qualification of additive manufacturing materials