Abstract:To reduce the oxygen content on the surface of alumina dispersion-strengthened copper alloy powders, and improve properties of the deposits prepared by cold spray additive manufacturing, these powders were pretreated with hydrogen reduction treatment at 300 °C and 500 °C, respectively. The microstructure and mechanical and electrical properties of the deposits before and after powder heat treatment were systematically researched. The results show that hydrogen reduction treatment can effectively reduce the oxide film on the surface of the alumina-dispersion-strengthened copper powder without changing the microstructure and mechanical properties of the powder. The alumina-dispersion-strengthened copper alloy deposit prepared from the as-received powder has obvious pores, and the tensile strength and electrical conductivity are 75 MPa and 38% IACS, while these deposits prepared from the powder treated at 300 °C and 500 °C present a dense microstructure. The tensile strengths and electrical conductivity are 202 MPa under 45% IACS and 245 MPa under 48% IACS, respectively. At the same time, the nano-Al 2 O 3 particles are very stable under the heating and deformation conditions of adiabatic shearing by cold spraying, and the Al 2 O 3 particles are not significantly broken during the severe plastic deformation caused by the high-speed impact of cold spraying, which enables the deposits to directly inherit the nano-dispersion strengthening structure of the powder. Therefore, it is effective to improve the mechanical and electrical properties of alumina dispersion-strengthened copper deposits by using hydrogen reduction pre-treatment to reduce the oxide film on the surfaces of the particles.

Preparation of Ultrafine Copper Powder with Copper Concentrate

Preparing of Ultrafine Copper Powder by Slurry Electrolysis

Preparation and Application of Ultrafine Copper Powder

A Catalytic Oxidation Approach to Coat Copper Powder with Polyaniline

Method for preparing antioxidated superfine copper powder

The Preparation of an Ultrafine Copper Powder by the Hydrogen Reduction of an Ultrafine Copper Oxide Powder and Reduction Kinetics

Coating Fine Copper Powder with Polyaniline

Anti-oxidation Technique of Conductive Ultrafine Copper Powder

Preparation and Characterization of Talc/Nano-Cu Conductive Composite Powder

Status-in-art of Preparation and Production of Ultra-fine Copper Powder in China

Preparation method of ultra-low-oxygen spherical micron copper powder

PREPARATION OF ULTRAFINE W–Cu COMPOSITE POWDER USING ULTRASONIC-ASSISTED ELECTROLESS PLATING

Development of Surface Anti-oxidation Treatment on Ultrafine Copper Powder

Preparation of fine copper powders by galvanostatic regime of electrolysis of copper scrap in a cylindrical electrochemical cell

Progress in Preparation of Ultrafine Copper Powder by Chemical Reduction Method

Preparation of ultrafine copper powders by NH2NH2 center dot H2O-HCHO direct reduction method and glucose prereruction method

Innovative Multiphase Ultrasonic-Assisted Method for High-Purity, Stable, and Cost-Effective Copper Nanowire Synthesis

Using design of experiments in synthesis of ultra-fine copper particles by electrolysis

A practical method to improve mechanical and electrical properties of ADS copper prepared by cold spray additive manufacturing through powder pretreatment

Preparation of Micron Size Cuprous Oxide Powder from Acidic CuCl2 Etchant Waste Solution

Study on new process of electroless copper plating pretreatment on carbon fiber surface