Determining mechanical properties of a pressure fire hose the type of «T»
Oleksiy Larin,Oleksandr Morozov,Sergii Nazarenko,Gennadiy Chernobay,Andrii Kalynovskyi,Roman Kovalenko,Svitlana Fedulova,Pavlo Pustovoitov
DOI: https://doi.org/10.15587/1729-4061.2019.184645
2019-11-22
Abstract:Experimental research into determining the mechanical properties (elastic and dissipative) of the pressure fire hose of type «T» with an inner diameter of 66 mm under conditions of static load were presented. The experiment was conducted on the experimental setup, which makes it possible to measure force and deformation. In the course of research, a series of field experiments in stretching with the sample under conditions of static loading-unloading cycles was carried out. The tests consisted of 5 cycles (modes) of loading-unloading, which were performed with a two-minute interval. Taking into consideration the experimental data, the elasticity module at stretching the material of the hose in the longitudinal (along the base) direction was determined. It was established that numerical results of mechanical properties depend on the hose loading «history», that is, in the first two load modes, elasticity modules increased and were stabilized only in the subsequent modes. The above, along with a significant reduction in residual deformations, increases the elastic properties of the fire hose material. The results of the conducted studies showed that in the first two cycles, the material demonstrates short-term creep, which gets stabilized in modes 4–5. To generalize the experimental research, the results were approximated by corresponding trend lines. The curves of the sample deformation, which under conditions of cyclic loading-unloading formed the hysteresis loops, were determined. The hysteresis loops obtained during the study showed that in the first two modes, the loop are subjected to quantitative and qualitative changes, specifically, the slope of the hysteresis loop and its area decreases. It was determined that a change of the properties of the material of the fire hose at consecutive loading-unloading deformation cycles are reversed, the gaps between the deformation cycles result in partial restoration of the mechanical characteristics, approximating them to the initial values. Relaxation time is from several hours to several days and even weeks, which depends heavily on the magnitude of the previous relative deformation