Abstract:Introduction . To improve the vibrating rollers in order to increase sealing capacity, reliability and vibration safety, the interaction of vibrating roller parts between each other and with compacted soil is simulated mathematically. The developed models are validated, i.e. compared with the results of experimental studies. However, the known results of experimental studies were obtained based on a relatively small list of vibrating roller models and soil types, as well as in a steady vibration mode. The paper presents the results of experimental studies, which used a vibratory drum of a roller to study its vertical vibration accelerations both in the steady vibration, as well as transient mode at turning the vibration generator on (speedup) and off (halt). This expands the range of opportunities to validate the existing and newly developed mathematical models. Materials and methods . Experimental studies of vertical vibration accelerations of a drum were conducted using the DM-617 vibrating roller when compacting natural sand-gravel aggregate. The accelerometer readings show high-frequency harmonics, which makes it significantly more difficult to determine amplitude values of vibration accelerations, therefore a low-frequency filter with a boundary frequency of 200 Hz was used for digital processing. Results . It was determined that when the DM-617 vibrating roller is compacting soil with maximum driving force within the range of variation of dynamic modulus of soil deformation E vd =14...25 MPа, amplitude values of vertical vibration accelerations of the vibratory drum are from 65... 77 to -61... -69 m/s2 . At the start-up (speedup) of vibration generator, acceleration amplitudes are 1.1 times higher than vertical accelerations of steady operation mode of the vibrating drum and practically do not depend on the dynamic modulus of soil deformation E vd . At turning off (stop) of the vibration generator, amplitude of vertical accelerations do not exceed the vertical accelerations of the steady operation mode of the vibratory drum. Discussion and conclusion . The vertical acceleration amplitudes of vibratory drums of DM-617 do not depend on the dynamic soil deformation modulus E vd , and this is consistent with the results of experimental studies of the vibratory drum mounted on DM-614. The obtained vertical vibration accelerations of the drum mounted on DM-617 in the steady vibration mode, as well as at switching the vibration generator on (speedup) and off (halt) make it possible to verify the existing and developed mathematical models of interaction of vibrating rollers with compacted soil. Financial transparency: the authors have no financial interest in the presented materials or methods. There is no conflict of interest.

Experimental studies on soil compaction using BOMAG BW 226 BVC-5 vibratory roller

RESULTS OF EXPERIMENTAL STUDIES OF ACCELERATIONS OF THE DM-617 VIBRATORY ROLLER USING DIGITAL SIGNAL PROCESSING TECHNOLOGY

The Dynamic Response of the Vibrating Compactor Roller, Depending on the Viscoelastic Properties of the Soil

Analysis of Subsoil Compaction by Vibratory Roller with Mutative Parameters

Consideration of the Variable Contact Geometry in Vibratory Roller Compaction

Discrete Element Modeling of Vibration Compaction Effect of the Vibratory Roller in Roundtrips on Gravels

An advanced ICMV for vibratory roller compaction

Experimental Research on Dynamic Performance for Vibratory Roller

Change of Structure of Dispersion Material Under Dynamic Loads

Centrifuge modelling of Continuous Compaction Control (CCC)

Dynamical response to vibration roller compaction and its application in intelligent compaction

Theoretical and Experimental Investigation on Dynamic Response of Asphalt Pavement under Vibration Compaction

Vibration Compaction Process Model for Rockfill Materials Considering Viscoelastic-Plastic Deformation

Discrete Simulation of Vibratory Roller Compaction of Field Rockfills

The Dynamic Performance of a Self Moving Roller

A Study on the Analysis of the Ground Compaction Effect According to the Roller Operation Method through CMV Analysis Using IC Rollers

Justification of chosen values of the weight coefficients of the compaction value for continuous compaction control systems for vibration rollers

ABAQUS-based research on the parameters of highway subgrade vibratory compaction and vibration wave propagation laws

Compaction Performance of Biomimetic Press Roller to Soil

A Dynamic Assessment of Rubber–Sand Mixtures as Subgrade Materials during Vibratory Roller Compaction through DEM Simulation in 2D

Study nonlinear vibration characteristics of vibrating roller-subgrade coupled system in the initial and middle stages of vibratory compaction