Abstract:There is extensive data to show that heating and cooling produces irrecoverable deformations in clays under fully drained conditions. The effects are most pronounced for normally and lightly overconsolidated clays that undergo significant compression. Most constitutive models have key limitations for predicting the thermo-mechanical response of clays through long-term (seasonal) cycles of heating and cooling. The Tsinghua ThermoSoil model (TTS; Zhang and Cheng in Int J Numer Anal Methods Geomech 41(4):527–554, 2017 ) presents a novel theoretical framework for simulating the coupled thermo-mechanical response of clays. The model uses a double-entropy approach to capture effects of energy dissipation at the microscopic particulate contact level on continuum behavior. This paper proposes a simple procedure for calibrating input parameters and illustrates this process using recent laboratory data for Geneva Clay (Di Donna and Laloui in Eng Geol 190:65–76, 2015 ). We then investigate capabilities of the TTS model in simulating familiar aspects of thermal consolidation of clays as well as the long-term, progressive accumulation of strains associated with seasonal heating and cooling processes for shallow geothermal systems installed in clays. The model predicts the existence of a long-term steady-state condition where there is no further accumulation of strain. This state depends on the consolidation stress and stress history but is independent of the imposed range of temperature, T cyc . However, the value of T cyc does affect the rate of accumulation of strain with thermal cycles. Simulations for normally consolidated Geneva Clay find steady-state strain conditions ranged from 2.0 to 3.7% accumulating within N = 10–50 thermal cycles.

Effects of Thermal Cycles on Soil Behaviour: Theoretical and Experimental Studies

A Unified Thermo-Mechanical Bounding Surface Model for Saturated Clay and Sand

Experimental Investigation of Soil–structure Interface Behaviour under Monotonic and Cyclic Thermal Loading

A Thermal State‐dependent Bounding Surface Model for Volume Change of Clay

A Two-Surface Thermomechanical Plasticity Model Considering Thermal Cyclic Behavior

A thermo-mechanical model for saturated and unsaturated soil-structure interfaces

Long Term Cyclic Behavior of Unsaturated Granular Soils

ON MODELING OF THERMO-MECHANICAL VOLUME CHANGE BEHAVIOR OF SATURATED CLAYS

A new state-dependent constitutive model for cyclic thermo-mechanical behaviour of unsaturated vegetated soil

A Unified Thermo Elastoplastic Constitutive Model Describing The Temperature Effect Of Saturated And Unsaturated Soils

Effects of Temperature and Thermal Cycles on the Elastic Shear Modulus of Saturated Clay

Volume Change Behavior of Unsaturated Soils under Non-Isothermal Conditions

Simulation of Long-Term Thermo-Mechanical Response of Clay Using an Advanced Constitutive Model

A Thermo-elastoplastic Constitutive Model for Soil and Its Application in Multiply Phase Coupling Numerical Simulation

Experimental Study on Thermal Effect of Deep-Sea Cohesive Sediment under Monotonic and Cyclic Loads

Undrained Dynamic Behaviour of Peaty Organic Soil under Long-Term Cyclic Loading, Part II: Constitutive Model and Simulation

Finite Element Analyses of Rate-Dependent Thermo-Hydro-mechanical Behaviors of Clayey Soils Based on Thermodynamics

A Thermo-Elasto-Plastic Constitutive Model For Saturated Clay Based On Disturbed State Concept

A Thermodynamic Constitutive Model for Undrained Monotonic and Cyclic Shear Behavior of Saturated Soils

A Thermo-Hydro-mechanical Constitutive Model and Its Numerical Modelling for Unsaturated Soils

A Simple Single Bounding Surface Model for Undrained Cyclic Behaviours of Saturated Clays and Its Numerical Implementation