Abstract:The evolution of phase composition and mechanical properties and the formation of oxide layers on Fe40–xNiCoCrAlx (x = 5 and 10 at.%) alloys in long-term oxidation at 900 and 1000°C were studied. In the initial cast state, depending on the aluminum content and valence electron concentration, the alloys contain only an fcc solid solution (VEC = 8 e/a) or a mixture of fcc and bcc phases (VEC = = 7.75 e/a). Thin continuous oxide scales containing Cr2O3 and NiCr2O4 spinel formed on the surface of both alloys oxidized at 900°C for 50 h. A further increase in the annealing time to 100 h leads to the formation of aluminum oxide Al2O3 in the scale on the Fe30Ni25Co15Cr20Al10 alloy, having high protective properties. An increase in the oxidation temperature to 1000°C results in partial failure of the protective layer on the alloy with 10 at.% Al. Long-term holding at 900°C (100 h) + 1000°C (50 h) does not change the phase composition of the Fe35Ni25Co15Cr20Al5 alloy matrix, being indicative of its high thermal stability. In the two-phase Fe30Ni25Co15Cr20Al10 alloy, the quantitative ratio of solid solutions sharply changes: the amount of the bcc phase increases from 4 to 54 wt.% and its B2-type ordering is observed. The mechanical characteristics of the starting alloys and those after long-term high-temperature annealing were determined by automated indentation. The hardness (HIT) and elastic modulus (E) of the cast Fe35Ni25Co15Cr20Al5 alloy are equal to 2 and 147 GPa, respectively, and decrease to 1.8 and 106 GPa after a series of long-term annealing operations. The Fe30Ni25Co15Cr20Al10 alloy shows the opposite dependence: HIT increases from 2.5 in the initial state to 3.1 GPa after annealing and E decreases from 152 to 134 GPa. This indicates that the Fe30Ni25Co15Cr20Al10 alloy is promising as a high-temperature oxidation-resistant and creep-resistant material.

Oxidation of a 2wt.%Hf–doped (Ta,C)-rich nickel–based alloy between 1100 and 1250°C

Oxidation of a 4 wt.% Hf-containing nickel-based alloy at temperatures ranging from 1100°C to 1250°C in air

Behaviors in Oxidation at 1100°C of an Equimolar CoNiFeMnCr High-Entropy Alloy and of its Versions Moderately Added with HfC or TaC Carbides

Dependence on the Chromium Content of the High-Temperature Oxidation Behavior of Ta-Rich Nickel-Based Cast Alloys

Improvement of the high temperature oxidation of TaC-strengthened Co(Cr)-based cast superalloys by the addition of nickel

Microstructure and oxidation behavior of the Y/Ta/Hf co-doped AlCoCrFeNi high-entropy alloys in air at 1100 °C

Oxidation behavior of high Hf nickel-based superalloy in air at 900, 1000 and 1100°C

Reaction with hot air of high entropy alloys strengthened by monocarbides formed from heavy metals: assessment of the oxidation kinetics from the analysis of the chemically changed subsurfaces

Structural State of High-Entropy Fe40–xNiCoCrAlx Alloys in High-Temperature Oxidation

High Temperature Oxidation Behavior of Ni-based High Entropy Superalloys

Effect of Chromium Content on the Oxidation Behavior of a Ta Stabilized Γ’-Strengthened Polycrystalline Co-30Ni-10Al-4W-4Ti-2Ta Alloy

High-Temperature Oxidation of NbTi-Bearing Refractory Medium- and High-Entropy Alloys

A Novel NiCoCrAlPt High-Entropy Alloy with Superb Oxidation Resistance at 1200 °C

Microstructure and Cyclic Oxidation of a Hf-doped (ni,pt)al Coating for Single-Crystal Superalloys

High-Temperature Oxidation Resistance of High-Nb TiAl-Based Alloy

ISOTHERMAL OXIDATION BEHAVIOR OF A SINGLE CRYSTAL NICKEL-BASED SUPERALLOY

Unraveling the Origin of the Excellent High-Temperature Oxidation Resistance of an AlCrFeNiTi Complex Concentrated Alloy

Effects of Ta Content on Microstructure and Oxidation Behavior of AlCoCrFeNiYTax High Entropy Alloy

EFFECT OF La AND Hf DOPANT ON THE HIGH TEMPERATURE OXIDATION OF CoNiCrAl ALLOYS

Oxidation Behavior Between 700 And 1300 Degrees C Of Refractory Tizrnbhfta High-Entropy Alloys Containing Aluminum

High-Temperature Oxidation Behaviour of a TiAl-Based Alloy Subjected to Aluminium Hot-Dipping