Abstract:The needs of metallic alloys able to work at elevated temperatures in severe conditions of applied mechanical stresses and chemical aggressivity of the environment is increasing more and more. For service temperatures equal to, or higher than, 1100°C, new superalloys must developed because of the loss in strengthening particles known by g/g ’ single crystals at so high temperatures, or the difficult availability of Oxide Dispersion Strengthened superalloys for geometrically complex hot components. Traditional metallurgical solutions are still a source of new superalloys development if innovative phases can be obtained in the microstructures. Carbides with complex constitutions represent a possible long-lasting strengthening system in cast polycrystalline alloys which are the most adapted alloys to produce coarse–grained complex pieces. In this work this is the (Hf, Ta) C strengthening system in a chromia–forming austenitic nickel–based matrix which was under interest. Interesting creep resistance at high temperature (e.g. 1100°C) were recently observed. In order to evaluate the chemical resistance at the same temperature for this type of materials, the same alloy was here exposed to synthetic air at 1100°C during 50 h in a thermobalance, followed by the post–mortem characterization of the oxidized states. To explore its oxidation resistance to more elevated temperatures this test was carried out 2 times more, at 1200°C and 1250°C. For these three temperatures this alloy well behaved in hot oxidation was good: chromia–forming behavior, rather slow oxidation kinetics and acceptable resistance against oxide scale spallation when cooling.

Reaction with hot air of high entropy alloys strengthened by monocarbides formed from heavy metals: assessment of the oxidation kinetics from the analysis of the chemically changed subsurfaces

Behaviors in Oxidation at 1100°C of an Equimolar CoNiFeMnCr High-Entropy Alloy and of its Versions Moderately Added with HfC or TaC Carbides

High-temperature oxidation behaviors of an equiatomic CrMnFeCoNi high entropy alloy

Oxidation and Hot Gas Corrosion of Al–Cr–Fe–Ni‐Based High‐Entropy Alloys with Addition of Co and Mo

Oxidation of a 2wt.%Hf–doped (Ta,C)-rich nickel–based alloy between 1100 and 1250°C

High-Temperature Oxidation Behavior of Al-Co-Cr-Ni-(Fe or Si) Multicomponent High-Entropy Alloys

Effect of Ti and C addition on oxidation resistance of FeCoCrNiMn high entropy alloys prepared by powder metallurgy

High-temperature oxidation behaviour of low-entropy alloy to medium- and high-entropy alloys

Improving the high temperature oxidation resistance of high entropy alloy by surface modification

Oxidation of a 4 wt.% Hf-containing nickel-based alloy at temperatures ranging from 1100°C to 1250°C in air

Dependence on the Chromium Content of the High-Temperature Oxidation Behavior of Ta-Rich Nickel-Based Cast Alloys

Microstructure and atmospheric oxidation behavior of CrCuFeMnNiCox high‐entropy alloys fabricated by vacuum hot‐press sintering

Microstructure and Early-Stage Oxidation Behavior of Co-Cr-Cu-Fe-Mn-Ni High-Entropy Alloys

Microstructure and oxidation behavior of the Y/Ta/Hf co-doped AlCoCrFeNi high-entropy alloys in air at 1100 °C

High-Temperature Oxidation Behavior of FeCoCrNi+(Cu/Al)-Based High-Entropy Alloys in Humid Air

Improving high-temperature oxidation behavior by modifying Al and Co content in Al-Co-Cr-Fe-Ni high-entropy alloy

High-Temperature Oxidation and Phase Stability of AlCrCoFeNi High Entropy Alloy: Insights from In Situ HT-XRD and Thermodynamic Calculations

Effect of Al and Ti on High-Temperature Oxidation Behavior of CoCrFeNi-Based High-Entropy Alloys

High-Temperature Oxidation Behavior of Refractory High-Entropy Alloys: Effect of Alloy Composition

High-temperature oxidation and diffusion studies on selected Al–Cr–Fe–Ni high-entropy alloys for potential application in thermal barrier coatings

High-temperature oxidation resistance of Al0.25CoCrFeNiSi0.6 high entropy alloy