Abstract:The modeling of the asymmetric cold rolling process of steel strip is carried out using the Deform program. During the study, the diameter of the barrel of the upper work roll is varied from 570 to 600 mm, the diameter of the barrel of the lower work roll was left unchanged at 600 mm, and changes in the structural parameters of the deformation zone, as well as the required rolling torques and forces, are recorded. The results are obtained for the conditions of rolling strips made of low-carbon steels with a thickness of 2 mm or more, as well as 0.35...0.5 mm. It is found that the discrepancy in power between the drives of the upper and lower rolls during asymmetric rolling can reach 25 % of the power required to conduct the process on rolls with the same barrel diameter. It is also shown that the changing of the contact arc with the indicated changes in power and a decrease in the diameter of the working roll barrel from 600 to 570 mm ranges from 3 to 5 % of the length of the arc of contact in the absence of a difference in the diameters of the barrels of the rolls. Fluctuation in moments when taking into account the factor of asymmetric rolling reaches 20 % of the corresponding values typical for the technological process on rolls with the same barrel diameter. An increase in the asymmetry of the rolling process leads to a slope of the neutral section in the deformation zone with an increase in the proportion of the advance zone in the arc of contact of the upper work roll with a smaller diameter of the barrel and the strip. An assumption is made, which requires further research, about the possibility of creating only one advance section along the entire length of the interaction of the roll with a smaller diameter of the barrel and the strip. Such a structure of the contact zone is theoretically able to reduce the required power of the main drive.

Numerical simulation of aeration in a hot rolling workshop

Natural Ventilation Design and Optimization of Large-Scale Industrial Workshop

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Numerical Simulation Research on the Temperature Field and Hot Roll Crown Model of Hot Continuous Rolling Mills

Numerical Simulation of Cast-rolling Process for Copper-Aluminum Composite Plate

Numerical simulation of cold longitudinal asymmetric rolling process

Numerical Simulation of Cold-state Air Flow Field in Fluidized Slag Cooler

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating

Numerical Simulation as a Tool for the Study, Development, and Optimization of Rolling Processes: A Review

Numerical Simulation of Steel Flow Through a One Strand Slab Tundish with Steel Flow Control Devices

Numerical simulation and optimization of steel tube billet heating process in rotary hearth furnace using CFD

Numerical Simulation of Plate Temperature Distribution During Hot Rolling

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

Numerical Simulation Of Ventilation Effectiveness In A Hangar

Numerical Simulation of the Solidification Process of a Heavy Roll Stand for Temperature Field and Thermal Stress Field

Numerical modelling and simulation in sheet metal forming

Numerical Simulation of Thermal Conductivity of Stainless Steel and Al-12Si Powders for Additive Manufacturing

Review of Numerical Simulation for the Cooling Process of the Structural Steel Hot Forging

Inverse determination of thermal boundary condition parameters in hot rolling process by numerical analytic method

Numerical Study on Cold Air Flow Field in Chain Stocker Boiler Added Front Arch

A New Control Volume-Based 2d Method for Calculating the Temperature Distribution of Rod During Multi-Pass Hot Rolling