Abstract:The physical and mechanical properties of rocks change significantly after being subjected to high temperatures, which poses safety hazards to underground projects such as coal underground gasification. In order to investigate the effect of temperature on the macroscopic and microscopic properties of rocks, this paper has taken sandstone as the research object and conducted uniaxial compression tests on sandstone specimens at different temperatures (20–1000 °C) and different heating rates (5–30 °C/min). At the same time, the acoustic emission (AE) test system was used to observe the acoustic emission characteristics of the rock damage process, and the microstructural changes after high temperature were analyzed with the help of a scanning electron microscope (SEM). The test results show that the effect of temperature on sandstone is mainly divided into three stages: Stage I (20–500 °C) is the strengthening zone, the evaporation of water and the contraction of primary fissures, and sandstone densification is enhanced. In particular, the compressive strength and elastic modulus increase, the macroscopic damage mode is dominated by shear damage, and the fracture micromorphology is mainly brittle fracture. Stage II (500–600 °C) is the transition zone, 500 °C is the threshold temperature for the compressive strength and modulus of elasticity, and the damage mode changes from shear to cleavage damage, and the sandstone undergoes brittle–ductile transition in this temperature interval. Stage III is the physicochemical deterioration stage. The changes in the physical and chemical properties make the sandstone compressive strength and modulus of elasticity continue to decline, the macroscopic damage mode is mainly dominated by cleavage damage, and the fracture microscopic morphology is of a more toughness fracture. The effect of different heating rates on the mechanical properties of sandstone was further studied, and it was found that the mechanical properties of the rock further deteriorated under higher heating rates.

Cyclic heating of saturated steam changes the surface properties of sandstone

Study on the effect of high-temperature dry–wet cycles on argillaceous sandstone

Thermal properties of sandstone after treatment at high temperature

Thermal damage and mechanical properties of high temperature sandstone with cyclic heating–cooling treatment

Variation of Wave Velocity and Porosity of Sandstone after High Temperature Heating

Experiment study of physical and mechanical properties of sandstone after variable thermal cycles

Influence of high-temperature thermal cycles on the pore structure of red sandstone

Effect of wet-dry cycling on the pore characteristics of red sandstone after heat treatment

Experimental study on changes of pore structure and mechanical properties of sandstone after high-temperature treatment using nuclear magnetic resonance

Surface properties of grayish-yellow sandstone after thermal shock

Abnormal Variation of P-wave Velocity of Red Sandstone after Cyclical Thermal Shock in Water

Effect of high temperature on physical properties of yellow sandstone

Physical and Mechanical Properties and Damage Mechanism of Sandstone at High Temperatures

Effects of high-temperature thermal treatment on the porosity of red sandstone: an NMR analysis

Changes in Surface Roughness of Sandstone after Heating and Cooling Cycles

Mechanical characteristics of sandstone after high temperatures

The impact of high temperature on mechanical properties and behaviors of sandstone

Changes in Glossiness, Electrical Properties and Hardness of Red Sandstone after Thermal Treatment

Experimental Study of the Mechanical and Acoustic Emission Characteristics of Sandstone by Using High-Temperature Water-Cooling Cycles

Evaluation of Thermophysical and Mechanical Properties of Sandstone Due to High-Temperature

Mechanical Characteristics of Sandstone under High Temperature and Cyclic Loading in Underground Coal Gasification