Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Experimental study on condensation friction pressure drop in rotating channels and proposal of new correlation

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

Evaluation of prediction models on frictional pressure drop for condensation flow in horizontal circular tubes

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Flow Pattern Study and Pressure Drop Prediction of Two-Phase Boiling Process in Different Surface Wettability Microchannel

Evaluation of Two-Phase Frictional Pressure Drop Correlations Against Experimental Data

New Correlations for Two Phase Flow Pressure Drop in Homogeneous Flows Model

A New General Correlation for Frictional Pressure Drop During Condensation Inside Horizontal Micro-Fin Tubes

Research on Flow and Condensation Heat Transfer Coefficient of multi-channel cylinder dryer in U-shaped Section

An Experimental Investigation of Pressure Drop in Two-Phase Flow during the Condensation of R410A within Parallel Microchannels

Evaluation of Existing Frictional Pressure Drop Correlations During Condensation of R410A in Four Horizontal Tubes

Flow Pattern, Heat Transfer and Frictional Pressure Drop Investigation of R365mfc Condensation in a Micro-Structured Corrugated Gap with Mixed Angles

Generalized Adiabatic Two-Phase Pressure Drop Correlation in Evaporative Micro/Mini-Channels

Analysis of Friction Factor of Two-Phase Flow in Helically Coiled Tubes

Frictional Pressure Drop Correlation of Steam-Water Two-Phase Flow in Helically Coiled Tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Evaluation of Frictional Pressure Drop Correlations During Flow Boiling of Refrigerants in Micro-Fin Tubes

A general correlation for adiabatic two-phase pressure drop in micro/mini-channels

A GENERAL FRICTIONAL PRESSURE DROP CORRELATION FOR CONDENSATION IN MICROFIN TUBES

Reliable smart models for estimating frictional pressure drop in two-phase condensation through smooth channels of varying sizes

New Friction Factor Correlation for Phase-Change Flow in Plate Heat Exchangers