Abstract:The experimental and theoretical researches have been carried out to get the flow boiling heat transfer characteristics of carbon dioxide (CO2 or R744) as a refrigerant in horizontal minichannel. Based on infrared thermal imaging tests and experimental studies on heat transfer coefficients, the heat transfer coefficients and dryout characteristics of CO2 are analyzed qualitatively and quantitatively in following conditions: Heat flux: 2 similar to 35 kW m(-2), Mass flux: 50 similar to 1350 kgm(-2) s(-1), saturation temperature: -10 similar to 15 degrees C, mini-channel inner diameter: 1 mmand 2 mm. Primary conclusions can be drawn from the results of the experiments: The increase of heat flux enhances the nucleate boiling heat transfer of the refrigerant inside mini-channel, which leads to the remarkable increase of heat transfer coefficient. But it speeds up the process of dryout. It also has a certain influence on vapor qualities of dryout at both the starting and the ending stage. The effect of mass flux on heat transfer enhancement depends on the dominant heat transfer mode in the tube. With the increase of mass flow rate, the vapor quality at the start of dryout has a decreasing trend. But the heat transfer coefficient increases at the end of dryout process or even after dryout process; the heat transfer coefficient does not vary monotonically with the saturation temperature: when the saturation temperature is high and even close to CO2' s critical temperature, the heat transfer coefficient increases with the increase of saturation temperature; when the saturation temperature is low, the heat transfer coefficient increases with the decrease of saturation temperature. Besides, during the heat transfer process, the dryout vapor quality falls monotonically with the increase of saturation temperature. It is reasonable to conclude that dryout characteristics have significant influence on heat transfer coefficient. Fang correlation that predicts the heat transfer coefficient of CO2 is in good agreement with the experimental data, which has a mean absolute deviation of 15.7%, and predicts 71.98% of the entire database within similar to 20% and 86.84% of the entire database within similar to 30%. (C) 2017 Elsevier Ltd and IIR. All rights reserved.

Research on Flow and Condensation Heat Transfer Coefficient of multi-channel cylinder dryer in U-shaped Section

Heat Transfer Characteristics of Condensation and Flow Regime in Horizontal Rectangle Channel of Multi-Channel Cylinder Dryer

Optimal Design of an Angular Box for a Mixed Flow Grain Dryer

Experimental study on condensation friction pressure drop in rotating channels and proposal of new correlation

Multi-phase Flow and Drying Characteristics in a Semi-Circular Impinging Stream Dryer

An Investigation of Heat Transfer of Flexible Fibers in a Rotating Drum Dryer Using the Discrete Element Method

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

A Research on the Dryout Characteristics of CO 2 'S Flow Boiling Heat Transfer Process in Mini-Channels

Experimental Study on Thermal–hydraulic Performance of Moist Air Inside Flat Tube of Two Kinds of Plate-Fin Heat Exchangers

Numerical Investigation of the Effect of Surface Wettability and Rotation on Condensation Heat Transfer in a Sludge Dryer Vertical Paddle

Investigations on Post-Dryout Heat Transfer in Bilaterally Heated Annular Channels

Investigation on Condensation Heat Transfer Outside Corrugated Tube

Convective drying of a moist porous object under the effects of a rotating cylinder in a channel

Analysis and structure optimization of the flow and temperature fields of the large-scale hot air drying room

Experimental Research on Convection–condensation Heat Transfer Characteristics and Sootblowing Operation Strategy of Waste Heat Recovery Heat Exchanger for Dryer Exhaust

Experimental research on double side enhanced heat transfer of water vapor condensation on spiral elliptical flat tube

Experimental analysis of convective drying of paper and board

Characteristic analysis of heat loss in multistage counter-flow paddy drying process

Study on the Heat Transfer Characteristics of Moisture Removal for Hollow Stationary Blade by Steam Heating

ANALYSIS OF TRANSPORT PHENOMENA DURING THE CONVECTIVE DRYING IN SUPERHEATED STEAM

Experimental Investigation on Performance of Desiccant Coated Microchannel Heat Exchangers under Condensation Conditions